Water Pump Impeller with Insert 47-F433065-2
- Guaranteed fitment for 8 different models
- This is an OEM part manufactured by Mercury Marine
- Flat rate shipping starting at $4.95
- 30 day return policy
Product Description
2 Product Questions
Len
Answer:
Yes, this impeller will fit your engine.
Bruce
Answer:
I am showing that part number F433065-2 will fit the Force 1988 50HP.
52 Product Reviews
Force 50 HP
Chrysler 55hp
Force 50hp
- Repair Difficulty
- Easy
- Repair Time
- More than 4 hours
Problem fixed: Fishing line wrapped around shaft and seal..prop..water in gear case.
Remove bearing housing..replace seal..replace fuel pump Diaphragm...holes in it..bought extra stuff like a nother Diaphragm and impeller(water pump)..prop cap and stuff.No hurry..retired.Boat runs great..been to mexico..sierras..so cal fresh and salt..85 Bayliner Capri. Little boat.Best regards...Randall
1988 Mariner 35 hp
- Repair Difficulty
- Easy
- Repair Time
- More than 4 hours
Problem fixed: Motor had been setting idle for more than 20+ years
I began the journey with a little clean-up. Replacing all fuel lines, filters, plus/wires and seals within the fuel/carburetor system. Turning the motor over by hand i used WD40 to help exercise the the top end, this worked great. The lower end rebuild was very simple and some what time consuming. The online exploded parts viewer was great for ordering and putting the components back in place. I believe i had less than 5 total hours in the rebuild and two days later and a few "small" adjustment the motor is running like new
force marine 50hp
mercury 40hp
- Repair Difficulty
- Easy
- Repair Time
- 2 to 4 hours
Problem fixed: Tune up and water pump repair
Rebuild carb replace float inlet needle valve, Rebuild the fuel pump Replace thermostat and remove lower unit and rebuild the water pump and replace the seal.
Force 50hp
- Repair Difficulty
- Easy
- Repair Time
- 30 to 60 mins
Problem fixed: Just doing Maintenance
Maintenance. Impeller and Thermostat
Force 40 horse
Force 50
Us Marine Force 50
Force 50hp
Mercury
- Repair Difficulty
- Easy
- Repair Time
- 30 to 60 mins
Problem fixed: Water pump
Easy to do took bad water pump out put new one in no problems part was right and job went really well
Force/50hp
force 50hp
1991 Force 50 hp
force 40 hp
- Repair Difficulty
- Easy
- Repair Time
- Less than 30 mins
Problem fixed: water pump impeller and plate
I have done a few of these on different motors . They are all pretty much the same. If you run in to trouble go to you tube type in your motor you should show you some thing. Good luck
50HP 1988 U.S Marine Force
- Repair Difficulty
- Easy
- Repair Time
- Less than 30 mins
Problem fixed: overheating
Just a word of caution, change the thermostat when doing the impellor. My engine overheated and stopped. After a head gasket change and thermostat, it seems to be running fine (head and block were still dead flat), but I realize now that it never pumped this much water since I've owned it (5 years). So the thermostat was probably bad for a long time. I installed a tell-tail on the top of the block. Crowley always has the right parts for this engine, which is hard to do for the 1988 and '89 years.
Force 35 hp
- Repair Difficulty
- Easy
- Repair Time
- Less than 30 mins
Problem fixed: would not start
got it going
force
40 hp force outboard
- Repair Difficulty
- Medium
- Repair Time
- More than 4 hours
Problem fixed: Rebuild of used motor
So far have readjusted the throttle linkage, installed new water pump impeller, installed new head gasket and am now chasing weak spark problems.
FORCE 50HP
- Repair Difficulty
- Easy
- Repair Time
- Less than 30 mins
Problem fixed: wasn't pumping water
replaced the impeller
Customers Also purchased
Supersession Chain
Name | SKU | Superceding SKU |
---|---|---|
Water Pump Impeller with Insert VIEWING THIS PRODUCT | F433065-2 | CURRENT |
Water Pump Impeller | F433065-1 | F433065-2 |
Water Pump Impeller | F433065 | F433065-1 |