Trim Switch Conversion Kit

Repair Time: 30 to 60 mins

Repair Difficulty: Easy

added February 14, 2019 at 3:55 PM updated May 16, 2019 at 8:34 PM

Trim Switch Conversion Kit

BRP Marine Outboard

SAFETY

These installation instructions contain information that can help prevent personal injury and damage to equipment. Understand the following symbols before proceeding:

Alerts you to the possibility of danger and identifies information that will help prevent injuries.

Identifies information that will help prevent damage to machinery.

Appears next to information that controls correct assembly and operation of the product.

TO THE OWNER

the assembly procedures outlined in this sheet should be performed by a skilled technician. If you have questions, see your DEALER. Save these instructions in your owner's kit. This sheet contains information important to the future use and maintenance of your engine.

TO THE INSTALLER

Give this sheet to the owner. Advise the owner of any special operation or maintenance information contained in the instructions.

PREFACE

This kit adds a trim switch to the handle of a non-trim surface mount remote control. This kit is compatible with Modular Wiring System and connects directly to a 1996 (ED) and newer motor. There is an adapter cable to connect to 1995 (EO) and earlier wiring harnesses.

1
Remove the handle from the control. For this procedure and the following procedures, see the Service Manual.

2
Remove the neutral lock slide (A).

[3]
Remove the handle cover (B), if on your control.

[4]
Remove the decal (C) from the handle.

[5]
Push the switch wires down in cover (1) next to the screw boss, and secure the cover to the handle with screws (2). Reinstall handle.

[6]
If this kit is being used with a 1995 (EO) or earlier wiring harness, connect adapter (3) to the switch cable.

Connect trim switch to Modular Wiring or wiring harness. Test switch operation.

0176517 - KIT AY,SWITCH-CONV

Share on social: