Johnson Evinrude Powerhead Installation

Tempo de Reparo: 1 to 2 hours

Dificuldade de Reparo: Professional

added 18 de setembro de 2019 às 20:50 updated 20 de setembro de 2019 às 17:09

BRP Marine Outboard

Install .0002" larger jets in carburetors.
Max timing MUST be retarded 2 degrees. Max timing MUST be set with engine running over 4500 RPM & under load. DO NOT STATIC SET MAX TIMING.
Re-torque cylinder heads to specs.
After 1 hour of break-in, allow engine to cool and retorque heads.
On 3 Cylinder engines, replace water pump with new high pressure water pump.
On 3 Cylinder engines, drill and relocate overboard sensors.
On 3 Cylinder engines, check latest OMC service bulletins and jet carburetors accordingly. THIS IS VERY IMPORTANT.
Use 92-94 octane premium fuel.
Clean and refill oil tank with TCW-3 oil.
Mark oil tank to verify oil comsumption during double oil usage of break-in period.
Run double oil during the first 30 gallons of fuel.
If running oil injection use 1 pint oil per 6 gallons gas.
If no oil injection, use 1 quart oil per 6 gallons gas.
Crowley Marine recommends installing water pressure gauge to monitor water flow.
Crowley Marine suggests removal of oil injection system or updating to latest VRO pump.
Crowley Marine recommends you replace water pump and gasket at time of powerhead replacement and every 2 years afterwards.

Share on social: