PREPARE-SE PARA O INVERNO: de 10 % a 50 % de desconto em todas as peças OEM!

A menos que seja proibido pelo fabricante. Não inclui produtos de reposição ou da marca Crowley Marine. Preço conforme marcado.

Os nossos armazéns encerram na quinta-feira, 26, e na sexta-feira, 27 de novembro. Feliz Dia da Thanksgiving dos Estados Unidos!

Contate-Nos
Procure por Mais de 1 Milhão de Peças Originais
Fáceis de usar  diagramas de peças Melhor preço  de garantia Especializado  suporte ao vivo Mais de 50 anos  servindo velejadores Enorme seleção de peças OEM  -  de 1950 a 2026 A maioria das peças em estoque  -  Cumprimento no mesmo dia
Peças em estoque- Realização no mesmo dia

Service Manual G2 74° V6 Service Manual 5010014 Gearcase [Shift Actuator]

Produtos Relacionados:
Service Manual G2 74° V6 Service Manual 5010014 Gearcase [Shift Actuator]
5010014
BRP Marine

Shift Actuator

Control Circuit Tests

Use appropriate test leads or adapters such as Test Probe Kit, P/N 342677, when performing electrical tests.
NEVER pierce the insulation of the engine wiring, or use any piercing-style test probe. Piercing insulation damages the wire and can cause other unintended electrical problems.

Circuit tests check the integrity of the main engine harness and EMM circuits using resistance or diode tests. Continuity tests check the integrity of ground circuits and/or the 55V circuit. These tests eliminate the need to disconnect the engine harness from the EMM, or remove the EMM.

Remove the electrical connector from the shift actuator.

Make sure the key switch is OFF.

Use the diode test function of a digital multimeter to check the shift actuator circuits. Use an appropriate test probe lead to connect the negative meter lead to the wire listed in the table, connect the positive meter lead to an engine ground.

  1. Engine harness connector (shift actuator)
Shift Actuator Circuit Diode Test
Wire Pin Result
Yellow/Blue 1 approximately 0.5 VDC
Yellow/Green 2 approximately 0.5 VDC
Red/White 3 0.11 to 0.125 VDC
Yellow/Black 4 2.1± 0.5 VDC

Results:

  • No reading (OL or ∞) indicates an open circuit.
  • A reading of zero (0) indicates an short circuit. Isolate the faulty component. Check wiring and connections. Repair or replace faulty wiring.

Shift Actuator Ground Circuit

Use a digital multimeter with appropriate test probe leads to measure the ground circuit resistance. Connect the positive meter lead to the engine harness connector wire listed in the table. Connect the negative meter lead to engine ground.

Shift Actuator Ground Circuit Resistance
Wire Pin Result
Black/White 5 < 1 Ω

Results:

An infinite reading (∞) indicates an open circuit. Isolate the faulty component. Check wiring and connections. Repair or replace faulty wiring.

Neutral Circuit

There are no tests for the neutral circuit.

Share on social:

Produtos Relacionados