DASH CONNECTIONS, INSTRUMENT HARNESS
DRC6165R
Instrument Harness Diagram
3-pin connector – Connect to trim switch located in the handle of the remote control or to trim switch mounted on the boat dash.
6-pin connector – Connect to a pre-wired remote control or to a dash-mounted key switch.
Black, purple, white/tan wires – Connect to the trim gauge.
8-pin connector – Connect to a 2 in. SystemCheck gauge or to a 3 1/2 in. SystemCheck tachometer.
2-pin connector – Must connect to the warning horn in all installations.
Black, purple, gray wires – Connect to a conventional tachometer when a SystemCheck tachometer is not used.
