PREPARE-SE PARA O INVERNO: de 10 % a 50 % de desconto em todas as peças OEM!

A menos que seja proibido pelo fabricante. Não inclui produtos de reposição ou da marca Crowley Marine. Preço conforme marcado.

Os nossos armazéns encerram na quinta-feira, 26, e na sexta-feira, 27 de novembro. Feliz Dia da Thanksgiving dos Estados Unidos!

Contate-Nos
Procure por Mais de 1 Milhão de Peças Originais
Fáceis de usar  diagramas de peças Melhor preço  de garantia Especializado  suporte ao vivo Mais de 50 anos  servindo velejadores Enorme seleção de peças OEM  -  de 1950 a 2026 A maioria das peças em estoque  -  Cumprimento no mesmo dia
Peças em estoque- Realização no mesmo dia

Service Manual DF70, DF60 Troubleshooting [33][Df70, Df60]

Produtos Relacionados:
Service Manual DF70, DF60 Troubleshooting [33][Df70, Df60]
99500-99E13-01E
Suzuki Marine

TROUBLESHOOTING

Before starting troubleshooting, read and follow the “PRECAUTION ON SYSTEM INSPECTION”
section on the page 3-36.

In this section, troubleshooting procedures are based on the assumption that “low pressure fuel system” and
“mechanical components (power unit, lower unit, etc.)” are normal.

For troubleshooting of “Starter motor will not run”, see the page 4-6.

CHART 1: SELF-DIAGNOSTIC CODE “3-4”

CHART 2: SELF-DIAGNOSTIC CODE “4-2”

CHART 3: SELF-DIAGNOSTIC CODE “3-1”

CHART 4: SELF-DIAGNOSTIC CODE “2-4”

CHART 5: SELF-DIAGNOSTIC CODE “2-2”

CHART 6: SELF-DIAGNOSTIC CODE “1-4”

CHART 7: SELF-DIAGNOSTIC CODE “2-3”

CHART 8: SELF-DIAGNOSTIC CODE “3-2”

CHART 9: SELF-DIAGNOSTIC CODE “1-1”

This self-diagnostic code indication may be canceled by turning the ignition switch ON because the ECM detects battery voltage.

It is difficult to check the rectifier & regulator completely. Before replacing with new one, check if its ground
point has good electrical contact.

CHART 10: SELF-DIAGNOSTIC CODE “1-5”

CHART 11: SELF-DIAGNOSTIC CODE “4-3”

CHART12: ENGINE CRANKED, BUT NOT START (OR STOPS SHORTLY AFTER STARTING)

Before starting this troubleshooting, make sure that:

• There is no self-diagnostic code indication.

• Emergency stop switch plate is set in place.

CHART 13: UNSTABLE IDLING/TROLLING (OR ENGINE TENDS TO STALL)

Before starting this troubleshooting, make sure that:
• There is no self-diagnostic code indication.

If the neutral switch has failed (while engine running), the engine will tend to stall when shifting into gear.
If the neutral switch has failed as “always ON”, the engine speed is limited to 3 000 r/min by intermittent fuel
injection and ignition timing is fixed at BTDC 9°. If the neutral switch has failed as “always OFF”, the engine can not cranked.

If the CTP switch has failed, the engine will tend to stall when decelerating.

• The self-diagnostic code “3-1” may not be indicated because the IAC valve condition depends on the ECM control. (See the page 3-29.)
• If the IAC valve has failed, “Fast-idle function (warm-up mode)” won’t operate.

Share on social:

Produtos Relacionados