PREPARE-SE PARA O INVERNO: de 10 % a 50 % de desconto em todas as peças OEM!

A menos que seja proibido pelo fabricante. Não inclui produtos de reposição ou da marca Crowley Marine. Preço conforme marcado.

Os nossos armazéns encerram na quinta-feira, 26, e na sexta-feira, 27 de novembro. Feliz Dia da Thanksgiving dos Estados Unidos!

Contate-Nos
Procure por Mais de 1 Milhão de Peças Originais
Fáceis de usar  diagramas de peças Melhor preço  de garantia Especializado  suporte ao vivo Mais de 50 anos  servindo velejadores Enorme seleção de peças OEM  -  de 1950 a 2026 A maioria das peças em estoque  -  Cumprimento no mesmo dia
Peças em estoque- Realização no mesmo dia

Service Manual DF70, DF60 Pinion Gear Back-Up Shim [88][Df70, Df60]

Produtos Relacionados:
Service Manual DF70, DF60 Pinion Gear Back-Up Shim [88][Df70, Df60]
99500-99E13-01E
Suzuki Marine

PINION BEARING

Removal/installation is in the following procedure.

Removal & Installation Tools

        09951-59910: Shaft (removal & installation) (1)
        09551-39914: Plate (2)
        01500-08403: Bolt (3)
        09951-19421: Attachment (4)
        09917-98221: Spacer (Attachment) (5)
        09930-30104: Sliding hammer (6)

REMOVAL

  1. Place the attachment 4 inside the pinion bearing.

  2. Insert the shaft (1) into the attachment (4).

  3. Thread the sliding hammer (6) into the top of the shaft (1).

  4. Put a wood block under the pinion bearing.

  5. Drive the pinion bearing out downward by striking the top of the shaft (1) with the sliding hammer (6).

● When removing the pinion bearing, use care to avoid damaging the gearcase.
● Do not re-use the pinion bearing once removed.
Always use a new pinion bearing.

INSTALLATION

● Before installing the bearing, ensure that the inside of the gearcase is clean and free of debris.
● Ensure that the bearing stamped mark faces upward.

  1. Set the shaft (1), the plate (2), the spacer (5), the attachment (4) and the pinion bearing as shown in the figure.

  2. Place the shaft 1 (with the pinion bearing on the end of the shaft) into the gearcase.

  3. Secure the plate (2) by tightening the bolts (3).

  4. Thread the sliding hammer (6) into the top of the shaft (1).

  5. Drive the pinion bearing down into position by gently striking the shaft 1 until the dimension between the undersurface of the shaft (1) shoulder and the top surface of the plate (2) become 3 mm.

Share on social:

Produtos Relacionados