PREPARE-SE PARA O INVERNO: de 10 % a 50 % de desconto em todas as peças OEM!

A menos que seja proibido pelo fabricante. Não inclui produtos de reposição ou da marca Crowley Marine. Preço conforme marcado.

Os nossos armazéns encerram na quinta-feira, 26, e na sexta-feira, 27 de novembro. Feliz Dia da Thanksgiving dos Estados Unidos!

Contate-Nos
Procure por Mais de 1 Milhão de Peças Originais
Fáceis de usar  diagramas de peças Melhor preço  de garantia Especializado  suporte ao vivo Mais de 50 anos  servindo velejadores Enorme seleção de peças OEM  -  de 1950 a 2026 A maioria das peças em estoque  -  Cumprimento no mesmo dia
Peças em estoque- Realização no mesmo dia

Service Manual DF70, DF60 Battery Charging System [36][Df70, Df60]

Produtos Relacionados:
Service Manual DF70, DF60 Battery Charging System [36][Df70, Df60]
99500-99E13-01E
Suzuki Marine

BATTERY CHARGING SYSTEM

OUTLINE

The battery charging system circuit is illustrated below.
It is composed of the battery charge coil, the rectifier & regulator and the battery.
The three phase AC current generated from the battery charge coil is converted by the rectifier & regulator into regulated DC current which is used to charge the battery.

Battery charge coil resistance

INSPECTION
BATTERY CHARGE COIL

09930-99320: Digital tester
Tester range: Ω (Resistance)

  1. Disconnect the battery charge coil wire from the rectifier & regulator.

  2. Measure resistance between the terminals for all combinations.

Terminal for testerprobe connection Resistance
Yellow 1 to Yellow 2 0.3 – 0.5 Ω
Yellow 1 to Yellow 3 0.3 – 0.5 Ω
Yellow 2 to Yellow 3 0.3 – 0.5 Ω

If the measurement is out of the specification, replace the bat tery charge coil.

RECTIFIER & REGULATOR
09930-99320: Digital tester
Tester range: Ω (Resistance)

  1. Disconnect all wires of the rectifier & regulator.

  2. Measure resistance between the terminals for all combinations.

The values given below are for the SUZUKI digital tester. As thyristors, diodes, etc. are used inside this rectifier & regulator, the resistance values will differ when an ohmmeter other than the SUZUKI digital tester is used.

Rectifier & regulator resistance

If the measurement is out of the specification, replace the rectifier & regulator.

REMOVAL/INSTALLATION

(1) Bolt (1)
(2) Washer (1)
(3) Key (1)
(4) Flywheel (1)
(5) Battery charge coil (1)
(6) Screw (3)
(7) Rectifier & regulator (1)
(8) Bolt (2)

REMOVAL

Before removing electrical parts:
• Disconnect battery cables from battery

Battery charge coil

  1. Remove the flywheel. (See page 3-52.)
  2. Remove the three screws.
  3. Disconnect the battery charge coil lead wire.

Rectifier & regulator

  1. Remove the electric parts holder. (See page 4-17.)
  2. Remove the two bolts.

INSTALLATION

Installation is reverse order of removal with the special attention to the following step.

Battery charge coil

Apply the thread lock to the coil securing screws.
99000-32050: THREAD LOCK “1342”

Share on social:

Produtos Relacionados