PREPARE-SE PARA O INVERNO: de 10 % a 50 % de desconto em todas as peças OEM!

A menos que seja proibido pelo fabricante. Não inclui produtos de reposição ou da marca Crowley Marine. Preço conforme marcado.

Os nossos armazéns encerram na quinta-feira, 26, e na sexta-feira, 27 de novembro. Feliz Dia da Thanksgiving dos Estados Unidos!

Contate-Nos
Procure por Mais de 1 Milhão de Peças Originais
Fáceis de usar  diagramas de peças Melhor preço  de garantia Especializado  suporte ao vivo Mais de 50 anos  servindo velejadores Enorme seleção de peças OEM  -  de 1950 a 2026 A maioria das peças em estoque  -  Cumprimento no mesmo dia
Peças em estoque- Realização no mesmo dia

Service Manual DF40, DF50 Priority Code Pattern For Self-Diagnostic System Operation [65][Df40, Df50]

Produtos Relacionados:
Service Manual DF40, DF50 Priority Code Pattern For Self-Diagnostic System Operation [65][Df40, Df50]
99500-87J08-01E
Suzuki Marine

SELF-DIAGNOSTIC SYSTEM

The self-diagnostic system alerts the operator when an abnormality occurs in a signal from sensor, switch, etc.

When the system is activated, the “CHECK ENGINE” lamp flashes (lights intermittently) according to each code pattern along with a buzzer sound.

When engine is running, the buzzer sounds a series of short (0.2 sec.) beeps.

When engine is not running, the buzzer sounds according to each code pattern, but not simultaneous with the lamp flash.

The buzzer sound, activated by the self-diagnostic system, can be temporally canceled by pushing the ignition key in.

PRIORITY / CODE / PATTERN FOR SELF-DIAGNOSTIC SYSTEM OPERATION

• If more than two items fail at once, the self- diagnostic indication appears according to priority order. The indication repeats three times.
• If the failed item remains, the self-diagnostic indication appears again after turning the ignition switch “ON”.
• After correcting failed item, the self-diagnostic indication appears until the ECM receives the proper signal with the engine running.
• For cylinder temp. sensor, exhaust manifold temp. sensor or IAT sensor the self-diagnostic indication will be canceled after corrective action by turning the ignition switch “ON”.
(The ECM will require 10 – 20 seconds after turning the ignition switch “ON” to cancel the self-diagnostic indication.)

• No spark or injection signal will be supplied to the cylinder corresponding to the faild CKP sensor.
• If two or more CKP sensors have failed at the same time, the engine will stop.

The self-diagnostic indication may be canceled by turning ignition switch “ON” because the ECM detects only battery voltage, not charging output. Under this condition the buzzer will not sound a 1-1 code.
However, if the rectifier & regulator have failed, the self-diagnostic indication will again appear after starting the engine.

Share on social:

Produtos Relacionados