PREPARE-SE PARA O INVERNO: de 10 % a 50 % de desconto em todas as peças OEM!

A menos que seja proibido pelo fabricante. Não inclui produtos de reposição ou da marca Crowley Marine. Preço conforme marcado.

Os nossos armazéns encerram na quinta-feira, 26, e na sexta-feira, 27 de novembro. Feliz Dia da Thanksgiving dos Estados Unidos!

Contate-Nos
Procure por Mais de 1 Milhão de Peças Originais
Fáceis de usar  diagramas de peças Melhor preço  de garantia Especializado  suporte ao vivo Mais de 50 anos  servindo velejadores Enorme seleção de peças OEM  -  de 1950 a 2026 A maioria das peças em estoque  -  Cumprimento no mesmo dia
Peças em estoque- Realização no mesmo dia

Service Manual DF40, DF50 Precaution On System Inspection [73][Df40, Df50]

Produtos Relacionados:
Service Manual DF40, DF50 Precaution On System Inspection [73][Df40, Df50]
99500-87J08-01E
Suzuki Marine

Step 1: PRECAUTION ON SYSTEM INSPECTION

To prevent an unexpected engine start, perform the following before proceeding with any CRANKING tests.
• When performing tests not related to fuel injector operation :
• Disconnect all fuel injector wire connectors.
• When performing tests related to fuel injector operation :
• Relieve fuel pressure in line. (See page 5-2.)
• Disconnect high pressure fuel pump wire connector located on fuel vapor separator.

• Always turn ignition switch “OFF” and disconnect battery cables when wires are being disconnected or connected.
• Hold and pull connector pieces when disconnecting. Do not pull wires.

• The self-diagnostic code memory in ECM will remain even if battery is disconnected.
• As each terminal voltage is affected by battery voltage, use a full-charged battery.
• Make sure all ground points have good electrical contact.
• Make sure all wires/cables are securely connected.

Step 2: INSPECTION FOR ECM CIRCUIT VOLTAGE

ECM cannot be bench checked. It is strictly prohibited to connect any tester (voltmeter or ohmmeter) to an ECM separated from the engine wiring harness.

(1) Connect the test cord 1,2,3 or 4 between ECM and wire harness as shown.

(2) Turn ignition switch ON.

(3) Connect the tester probe - (Black) to body ground, and measure voltage according to the “CIRCUIT VOLTAGE TABLE”.

Share on social:

Produtos Relacionados