PREPARE-SE PARA O INVERNO: de 10 % a 50 % de desconto em todas as peças OEM!

A menos que seja proibido pelo fabricante. Não inclui produtos de reposição ou da marca Crowley Marine. Preço conforme marcado.

Os nossos armazéns encerram na quinta-feira, 26, e na sexta-feira, 27 de novembro. Feliz Dia da Thanksgiving dos Estados Unidos!

Contate-Nos
Procure por Mais de 1 Milhão de Peças Originais
Fáceis de usar  diagramas de peças Melhor preço  de garantia Especializado  suporte ao vivo Mais de 50 anos  servindo velejadores Enorme seleção de peças OEM  -  de 1950 a 2026 A maioria das peças em estoque  -  Cumprimento no mesmo dia
Peças em estoque- Realização no mesmo dia

Service Manual DF40, DF50 Oil Pressure [39][Df40, Df50]

Produtos Relacionados:
Service Manual DF40, DF50 Oil Pressure [39][Df40, Df50]
99500-87J08-01E
Suzuki Marine

OIL PRESSURE

Oil pressure ( at normal operating temp. ): 300 - 380 kPa (3.0 - 3.8 kg/cm2, 43 - 54 psi.) at 4000 r / min.

The figure shown above is a guideline only, not an absolute service limit.
If oil pressure is lower or higher than specification, the following causes may be considered.
(See page 6-66 for oil passage locations)

Low oil pressure
• Clogged oil filter
• Leakage from oil passages
• Defective oil pump
• Defective oil pressure regulator
• Damage O-ring
• Combination of above items.

High oil pressure
• Using an engine oil of too high viscosity
• Clogged oil passage
• Clogged oil pressure regulator
• Combination of above items

TEST PROCEDURE

(1) Check the engine oil level.
(2) Remove the PORT side lower cover.
(3) Remove the plug (1) for oil pressure service port.

(4) Install the oil pressure gauge in place of service port.

09915-77310 : Oil pressure gauge
09915-78211 : Oil pressure gauge adapter

(5) Remove bolt and No.1 ignition coil.
(6) Connect special tool (H . T cord with plug cap adapter) between No.1 ignition coil and spark plug.

09930-88720 : H . T cord with plug cap adapter

(7) Attach engine tachometer to the special tool.

09900-26006 : Engine tachometer

(8) Start the engine and warm up engine as follow :

Summer : 5 min. at 2000 r / min.
Winter : 10 min. at 2000 r / min.

(9) After warming up, shift into forward gear and increase the engine speed to 4000 r / min. then compare the pressure indicated on the gauge to specifications.

(10) After testing, reinstall parts removed earlier. (plug, side lower cover, etc.)

Share on social:

Produtos Relacionados