PREPARE-SE PARA O INVERNO: de 10 % a 50 % de desconto em todas as peças OEM!

A menos que seja proibido pelo fabricante. Não inclui produtos de reposição ou da marca Crowley Marine. Preço conforme marcado.

Os nossos armazéns encerram na quinta-feira, 26, e na sexta-feira, 27 de novembro. Feliz Dia da Thanksgiving dos Estados Unidos!

Contate-Nos
Procure por Mais de 1 Milhão de Peças Originais
Fáceis de usar  diagramas de peças Melhor preço  de garantia Especializado  suporte ao vivo Mais de 50 anos  servindo velejadores Enorme seleção de peças OEM  -  de 1950 a 2026 A maioria das peças em estoque  -  Cumprimento no mesmo dia
Peças em estoque- Realização no mesmo dia

Service Manual DF40, DF50 Oil Change Reminder System [236][Df40, Df50]

Produtos Relacionados:
Service Manual DF40, DF50 Oil Change Reminder System [236][Df40, Df50]
99500-87J08-01E
Suzuki Marine

Step 1: OIL CHANGE REMINDER SYSTEM

This system informs the operator of the time for replacing ENGINE OIL on the basis of the recommended maintenance schedule.

When the total motor operating hours have reached the preprogrammed hours;

  • On the tiller handle model, the buzzer will begin a series of double beeps for approx. 1 minute.
  • On the remote control model, the “OIL” lamp will flash, and the buzzer will begin a series of double beeps if engine is not running (but ignition switch is ON).

The above mentioned indication will repeat until canceling system activation.

Step 2: INDICATION OF SYSTEM ACTIVATION

Tiller Handle Model

Remote Control Model

On the tiller handle model, the buzzer for system activation will first begin to sound when the engine is stopped (but ignition switch is ON) after reaching the preprogrammed hours.

Buzzer         OIL lamp

Step 3: FLOWCHART OF SYSTEM ACTIVATION AND CANCELLATION

*1 : Lapse of initial 20 hour’s operation
*2 : Lapse of 80 hour’s operation
*3 : Lapse of 100 hour’s operation
*4 : When performing cancellation before system activation

This system will activate up to 2100 hour’s operation.

Step 4: CANCELLATION

Procedure

  1. Turn the ignition key to the “ON” position.
  2. Pull out the emergency stop switch plate (1).
  3. Pull up the emergency stop switch knob (2) three times in seven seconds. A short beep will be heard if the cancellation is successfully finished.
  4. Turn the ignition key to the “OFF” position.
  5. Set the plate (1) in the original position.

• Canceling of the system activation is possible regardless of whether or not the engine oil has been replaced. Once the system has operated, however, Suzuki strongly recommends that the engine oil be replaced before canceling the system activation.
• Even if the engine oil has been replaced with the system not operating, it is still necessary to perform the cancellation.

Share on social:

Produtos Relacionados