PREPARE-SE PARA O INVERNO: de 10 % a 50 % de desconto em todas as peças OEM!

A menos que seja proibido pelo fabricante. Não inclui produtos de reposição ou da marca Crowley Marine. Preço conforme marcado.

Os nossos armazéns encerram na quinta-feira, 26, e na sexta-feira, 27 de novembro. Feliz Dia da Thanksgiving dos Estados Unidos!

Contate-Nos
Procure por Mais de 1 Milhão de Peças Originais
Fáceis de usar  diagramas de peças Melhor preço  de garantia Especializado  suporte ao vivo Mais de 50 anos  servindo velejadores Enorme seleção de peças OEM  -  de 1950 a 2026 A maioria das peças em estoque  -  Cumprimento no mesmo dia
Peças em estoque- Realização no mesmo dia

Service Manual DF40, DF50 Installation [131][Df40, Df50]

Produtos Relacionados:
Service Manual DF40, DF50 Installation [131][Df40, Df50]
99500-87J08-01E
Suzuki Marine

ASSEMBLY

(1) Wash, clean and then dry all disassembled parts.
(2) Apply thin coat of engine oil to inner and outer rotors, oil seal lip and inside surfaces of oil pump case and plate.
(3) Install outer and inner rotor to pump case.

(4) Install outer plate.

Tighten six (6) screws securely.

After mounting the outer plate, check to be sure that each rotor turns smoothly by hand.

INSTALLATION

Installation is reverse of removal with special attention to following steps.

  1. Check for proper timing chain installation. (see page 6-20)

  2. Install two (2) dowel pins to cylinder block.

Before fitting the pump case, oil the oil seal lip.

  1. Apply sealant to areas as shown in figure.

99000-31140 : Suzuki Bond 1207B

  1. Apply a continuous bead of sealant to oil pump case mating surface as shown in figure.

99000-31140 : Suzuki Bond 1207B

  1. Install oil pump case to cylinder block and tighten seven (7) bolts securely.

• When installing oil pump case be sure position of oil pump inner rotor matchs with crankshaft.
• Tighten bolts in the indicated order.

  1. Install dowel pin and gasket to oil pump case.
  2. Apply grease to oil seal lip.

99000-25161 : Water Resistant Grease

  1. Install under oil seal housing and tighten bolts.
Share on social:

Produtos Relacionados