PREPARE-SE PARA O INVERNO: de 10 % a 50 % de desconto em todas as peças OEM!

A menos que seja proibido pelo fabricante. Não inclui produtos de reposição ou da marca Crowley Marine. Preço conforme marcado.

Os nossos armazéns encerram na quinta-feira, 26, e na sexta-feira, 27 de novembro. Feliz Dia da Thanksgiving dos Estados Unidos!

Contate-Nos
Procure por Mais de 1 Milhão de Peças Originais
Fáceis de usar  diagramas de peças Melhor preço  de garantia Especializado  suporte ao vivo Mais de 50 anos  servindo velejadores Enorme seleção de peças OEM  -  de 1950 a 2026 A maioria das peças em estoque  -  Cumprimento no mesmo dia
Peças em estoque- Realização no mesmo dia

Service Manual DF40, DF50 Fuel Injection Control System [54][Df40, Df50]

Produtos Relacionados:
Service Manual DF40, DF50 Fuel Injection Control System [54][Df40, Df50]
99500-87J08-01E
Suzuki Marine

ELECTRONIC FUEL INJECTION SYSTEM

The fuel injection system used by the DF40/50 is a speed-density, multi-point, sequential, electronic fuel injection type. The fuel injection system is composed of the fuel line components, air intake components , and components for system control (ECM,sensors, switches, etc.).

FUEL INJECTION CONTROL SYSTEM

FUEL INJECTION CONTROL SYSTEM

OUTLINE

The sensors monitor current engine condition and send signals to the ECM. Based on these signals, the ECM determines the optimum fuel injection time duration (fuel amount) and fuel injection timing (multi point sequential timing) and controls the injector operating signals accordingly.
Fuel injection start timing is set at BTDC 545° on exhaust stroke constant.

FUEL INJECTION TIMING CHART

CONTROL MODE

BEFORE START :

When the ignition switch is turned “ON”, the ECM receives a MAP sensor signal, indicating the static barometric pressure of the intake manifold, which is used to compensate the fuel injection map for altitude.

WHEN CRANKING :
Fuel is simultaneously injected to all cylinders every time any piston is positioned at compression stroke.

AFTER START (FAST-IDLE FUNCTION):
The fuel injection amount is controlled to increase until the timer, set according to cylinder temperature at the time of engine start, expires.

WHEN IDLING / TROLLING :
The fuel injection amount is controlled to maintain a stable engine speed at the specified idle / trolling rpm.

WHEN ACCELERATING :
The fuel injection amount is controlled to increase.

WHEN DECELERATING :
The fuel injection amount is controlled to decrease.
The fuel injection is also cut off on very rapid engine deceleration.

Share on social:

Produtos Relacionados