PREPARE-SE PARA O INVERNO: de 10 % a 50 % de desconto em todas as peças OEM!

A menos que seja proibido pelo fabricante. Não inclui produtos de reposição ou da marca Crowley Marine. Preço conforme marcado.

Os nossos armazéns encerram na quinta-feira, 26, e na sexta-feira, 27 de novembro. Feliz Dia da Thanksgiving dos Estados Unidos!

Contate-Nos
Procure por Mais de 1 Milhão de Peças Originais
Fáceis de usar  diagramas de peças Melhor preço  de garantia Especializado  suporte ao vivo Mais de 50 anos  servindo velejadores Enorme seleção de peças OEM  -  de 1950 a 2026 A maioria das peças em estoque  -  Cumprimento no mesmo dia
Peças em estoque- Realização no mesmo dia

Service Manual DF40, DF50 Cylinder Compression [40][Df40, Df50]

Produtos Relacionados:
Service Manual DF40, DF50 Cylinder Compression [40][Df40, Df50]
99500-87J08-01E
Suzuki Marine

CYLINDER COMPRESSION

Cylinder compression :

Standard : 1300 – 1600 kPa (13 - 16 kg / cm2, 185 – 228 psi.)
Max. difference between any two cylinders : 100kPa (1.0 kg / cm2 , 14 psi.)

Figures shown are guidelines only, not absolute service limits.

Low compression pressure can indicate one or more of the following :

  • Excessively worn cylinder wall
  • Worn piston or piston rings
  • Stuck piston rings
  • Poor seating of valves
  • Ruptured or otherwise damaged cylinder head gasket

TEST PROCEDURE

(1) Start engine and allow to warm up, then shut engine off.

(2) Remove the STBD / PORT engine side lower cover.

(3) Remove all spark plugs.

(4) Install the compression gauge into the plug hole.

TOOL 09915-64512 : Compression gauge
09915-63210 : Compression gauge adaptor

(5) Disconnect the safety lanyard (switch plate) from the emergency stop switch.

Disconnect the safety lanyard from the emergency stop switch prior to cranking the engine.
This will prevent any residual fuel discharged from the cylinders being ignited by a spark discharge from the ignition coil.

(6) Disconnect the remote control throttle cable from the throttle lever.

(7) Move and hold the throttle lever in the full-open position.

(8) While cranking the engine with the starter motor, note the maximum compression pressure reading on the gauge for each cylinder.

(9) Reinstall parts removed earlier. ( spark plug, side lower cover, etc.)

Share on social:

Produtos Relacionados