PREPARE-SE PARA O INVERNO: de 10 % a 50 % de desconto em todas as peças OEM!

A menos que seja proibido pelo fabricante. Não inclui produtos de reposição ou da marca Crowley Marine. Preço conforme marcado.

Os nossos armazéns encerram na quinta-feira, 26, e na sexta-feira, 27 de novembro. Feliz Dia da Thanksgiving dos Estados Unidos!

Contate-Nos
Procure por Mais de 1 Milhão de Peças Originais
Fáceis de usar  diagramas de peças Melhor preço  de garantia Especializado  suporte ao vivo Mais de 50 anos  servindo velejadores Enorme seleção de peças OEM  -  de 1950 a 2026 A maioria das peças em estoque  -  Cumprimento no mesmo dia
Peças em estoque- Realização no mesmo dia

Service Manual DF40, DF50 Cleaning And Inspecting [171][Df40, Df50]

Produtos Relacionados:
Service Manual DF40, DF50 Cleaning And Inspecting [171][Df40, Df50]
99500-87J08-01E
Suzuki Marine

Disassembly of tilt rod / piston assembly

Unscrew the piston retaining nut from the bottom of the tilt rod and remove the washer.

Carefully retain and account for four shock valves, each com posed of a spring, rod and ball.

Remove the piston assembly and PTT cylinder head from the tilt rod by sliding them down and off the rod end.

CLEANING AND INSPECTING

Thoroughly wash all metal components with cleaning solvent and dry them with compressed air.

Arrange all components on a clean sheet of paper.

Do not lay PTT components out on a rag, as dirt or lint may be transferred to these items which may cause possible system operating problems.

Inspect tilt rod, replace if damaged or bent.

Inspect the surface of tilt rod for scores, grooves or roughness. Slight roughness may be removed with fine emery paper. A badly scored or grooved rod must be replaced.

Inspect the PTT cap seal and O-ring.

Replace if cuts, nicks, or excessive wear is found.

It is recommended that the O-ring always be replaced once the tilt cylinder has been disassembled.

Inspect the shock valves (spring, rod and ball). Replace if there are any signs of rust or pitting.

Inspect the cylinder bore for evidence of a rough or grooved surface.

Light honing may rectify slight surface roughness or scarring, but a deeply scarred surface will require replacement of the tilt cylinder.

Inspect all O-ring (manual release valve and main check valve). Replace if nicked or cut.

Share on social:

Produtos Relacionados