PREPARE-SE PARA O INVERNO: de 10 % a 50 % de desconto em todas as peças OEM!

A menos que seja proibido pelo fabricante. Não inclui produtos de reposição ou da marca Crowley Marine. Preço conforme marcado.

Contate-Nos
Procure por Mais de 1 Milhão de Peças Originais
Fáceis de usar  diagramas de peças Melhor preço  de garantia Especializado  suporte ao vivo Mais de 50 anos  servindo velejadores Enorme seleção de peças OEM  -  de 1950 a 2026 A maioria das peças em estoque  -  Cumprimento no mesmo dia
Peças em estoque- Realização no mesmo dia

Service Manual 5008738_115-200 HP 60° V Electrical And Ignition [Ground Circuits]

Produtos Relacionados:
Service Manual 5008738_115-200 HP 60° V Electrical And Ignition [Ground Circuits]
5008738
BRP Marine

Sections:

  1. GROUND CIRCUITS
  2. FUSE

GROUND CIRCUITS

All ground circuits are essential to reliable outboard performance. Make sure all ground connections are clean and tight. Refer to wiring diagrams
for specific wiring details.

EMM Ground Tests

Disconnect the battery cables at the battery.

Use an ohmmeter to check continuity of ground circuits. Calibrate the ohmmeter on the high ohms scale. Resistance readings for all ground circuits should be 0 W.

  • System/power supply grounds: Check continuity between terminal pins 4, 5, 9, 14, 15, 16, 23, 24, 25 and 27 of EMM J2 connector and the
    main harness ground.

  • Injector circuit grounds: Check continuity between terminal pins 9 and 27 of the EMM J2 connector and the main harness ground; and between terminal pins 9, 10, 15, 16 and 22 of the EMM J1-B connector and the main harness ground.

  • Sensor circuit grounds: Check continuity between terminal pins 4 and 11 of the EMM J1-A connector and the appropriate sensor ground connections. Refer to wiring diagrams.

  1. Main engine harness ground
  2. Ground stud (battery)

Additional Ground Tests

Check connections and continuity at the following locations:

  • Trim and Tilt module ground at main ground terminal.

FUSE

The engine harness 12 V (B+) circuit is protected by one automotive style 10 amp minifuse.

The fuse is located on the port side of the powerhead, in the flywheel cover.

  1. Fuse
  2. Spare fuse

IMPORTANT: Repeat failures of fuse could be the result of faulty connections or accessories. The 12 V accessory circuit (purple wire from terminal “A” of key switch) is often used to power accessories.

Share on social:

Produtos Relacionados