PREPARE-SE PARA O INVERNO: de 10 % a 50 % de desconto em todas as peças OEM!

A menos que seja proibido pelo fabricante. Não inclui produtos de reposição ou da marca Crowley Marine. Preço conforme marcado.

Contate-Nos
Procure por Mais de 1 Milhão de Peças Originais
Fáceis de usar  diagramas de peças Melhor preço  de garantia Especializado  suporte ao vivo Mais de 50 anos  servindo velejadores Enorme seleção de peças OEM  -  de 1950 a 2026 A maioria das peças em estoque  -  Cumprimento no mesmo dia
Peças em estoque- Realização no mesmo dia

Service Manual 5007215_Evinrude E-TEC 200-250 HP Installation And Predelivery [Before Start Up]

Produtos Relacionados:
Service Manual 5007215_Evinrude E-TEC 200-250 HP Installation And Predelivery [Before Start Up]
5007215
BRP Marine

BEFORE START-UP

Gearcase Lubricant

With outboard in vertical position, check the gear case lubricant level:

  • Remove the lubricant level plug. Lubricant must be even with the bottom of the threaded hole.
  • A clean tie strap can be used as a “dip stick” if the lubricant level is not obvious.
  • Add HPF XR gearcase lubricant as needed.

  1. Gearcase lubricant level

Oil Level

Make sure oil tank contains an adequate supply of the correct lubricant for the outboard and that the SystemCheck Low Oil Warning test has been performed.

When starting the outboard for the first time, refer to Oil Supply Priming on p. 67.

Trim and Tilt Fluid

Make sure trim and tilt reservoir is full before running outboard:

  • Tilt the motor up and engage the tilt support.
  • Remove filler cap and check fluid level.
  • If necessary, add enough Evinrude/Johnson Power Trim/Tilt and Power Steering Fluid to bring fluid level even with bottom of fill cap hole when unit is at full tilt.

  1. Filler cap
Share on social:

Produtos Relacionados