PREPARE-SE PARA O INVERNO: de 10 % a 50 % de desconto em todas as peças OEM!

A menos que seja proibido pelo fabricante. Não inclui produtos de reposição ou da marca Crowley Marine. Preço conforme marcado.

Os nossos armazéns encerram na quinta-feira, 26, e na sexta-feira, 27 de novembro. Feliz Dia da Thanksgiving dos Estados Unidos!

Contate-Nos
Procure por Mais de 1 Milhão de Peças Originais
Fáceis de usar  diagramas de peças Melhor preço  de garantia Especializado  suporte ao vivo Mais de 50 anos  servindo velejadores Enorme seleção de peças OEM  -  de 1950 a 2026 A maioria das peças em estoque  -  Cumprimento no mesmo dia
Peças em estoque- Realização no mesmo dia

Service Manual 5007213_Evinrude E-TEC 115-200 HP Cooling System [Pressure Relief Valve Servicing]

Produtos Relacionados:
Service Manual 5007213_Evinrude E-TEC 115-200 HP Cooling System [Pressure Relief Valve Servicing]
5007213
BRP Marine

THERMOSTAT SERVICING

Disassembly

Remove the thermostat cover and O-ring from each cylinder head. Remove each thermostat.

Inspection

Inspect all components for cracks, heat damage, or signs of corrosion. Replace damaged components. Clean debris from all housings and thermostat components.

Assembly

Assembly is essentially the reverse of disassembly. Pay close attention when performing the fol lowing additional tasks.

Coat threads of each cylinder head thermostat cover with Gasket Sealing Compound. Install and tighten the cover to a torque of 120 to 144 in. lbs. (13.6 to 16.3 N·m).

PRESSURE RELIEF VALVE SERVICING

Pressure relief valve assembly should be serviced at the same time as the thermostats.

Disassembly

Remove the EMM. Refer to EMM SERVICING on p. 153.

Remove the four screws holding the electrical har ness base.

  1. Harness base screws

Loosen electrical harness connections as necessary to lift harness base away from the pressure relief valve.

Remove screws and cap from pressure valve assembly.

  1. Pressure valve cap screws

Remove the pressure valve housing.

Remove the pressure valve components.

Inspection

Inspect all components for cracks, heat damage, or signs of corrosion. Replace damaged components. Clean all debris from pressure relief valve components.

Assembly

Assembly is essentially the reverse of disassembly. Pay close attention when performing the fol lowing additional tasks.

Torque cap screws to 60 to 84 in. lbs. (7 to 9.5 N·m).

Share on social:

Produtos Relacionados