PREPARE-SE PARA O INVERNO: de 10 % a 50 % de desconto em todas as peças OEM!

A menos que seja proibido pelo fabricante. Não inclui produtos de reposição ou da marca Crowley Marine. Preço conforme marcado.

Os nossos armazéns encerram na quinta-feira, 26, e na sexta-feira, 27 de novembro. Feliz Dia da Thanksgiving dos Estados Unidos!

Contate-Nos
Procure por Mais de 1 Milhão de Peças Originais
Fáceis de usar  diagramas de peças Melhor preço  de garantia Especializado  suporte ao vivo Mais de 50 anos  servindo velejadores Enorme seleção de peças OEM  -  de 1950 a 2026 A maioria das peças em estoque  -  Cumprimento no mesmo dia
Peças em estoque- Realização no mesmo dia

Service Manual 40-90 HP.E-TEC Midsection [Stern Bracket, 40-60 Hp Power Tilt]

Produtos Relacionados:
Service Manual 40-90 HP.E-TEC Midsection [Stern Bracket, 40-60 Hp Power Tilt]
5008148
BRP Marine

STERN BRACKET, 40 – 60 HP Power Tilt

the hole in the outer housing and the alignment pin into the adapter housing.

  1. Alignment pin

Apply Gasket Sealing Compound to threads of the four retaining screws and tighten to a torque of 60 to 84 in. lbs. (7 to 9.5 N·m).

  1. Adapter retaining screws

Stern Bracket Disassembly

Remove the bumpers from the upper mount retaining screws. Remove the screws, upper mount, and ground lead from the bracket.

Pull the steering arm out of the swivel bracket. Use an appropriate tool to pry the upper and lower seals from the swivel bracket.

To separate the swivel bracket from the stern bracket, remove one tilt tube nut.

Remove the tie bar to separate the two stern brackets.

Check the condition of the anode. Replace the anode if it has been reduced to two-thirds its original size.

Stern Bracket Assembly

Assemble the tie bar to the stern brackets. Place the ground lead and starwasher between the port stern bracket and tie bar.

Lubricate the swivel bracket bushings with Triple-Guard grease. Place the bushings in the swivel bracket.

Position the swivel bracket between the stern brackets. Place a thrust washer between each of the stern brackets and the swivel bracket.

Install the tilt tube. Tighten the tilt tube nuts 40 to 45 ft. lbs. (54 to 61 N·m), then back off 1/8 to 1/4 turn.

Apply Nut Lock to threads of the upper mount to steering arm screws. Install the mount and tighten the screws 24 to 26 ft. lbs. (32.5 to 35 N·m). Make sure to place the ground lead under the starboard screw.

Apply a liberal amount of Adhesive 847 to heads of the upper mount screws.

Place the bumpers on the upper mount screws.

STERN BRACKET, 75 – 90 HP Power Tilt

Stern Bracket Removal

Before servicing the stern bracket:

  • Remove gearcase. Refer to GEARCASE REMOVAL AND INSTALLATION on p. 354.

  • Remove powerhead. Refer to POWERHEAD REMOVAL on p. 228.

  • Remove exhaust housing. Refer to Exhaust Housing Removal on p. 284.

  • Remove power trim/tilt unit. Refer to TRIM AND TILT SERVICE on p. 388.

Stern Bracket Disassembly

Remove and discard steering shaft locknut.

Remove the lower mount bracket and keeper.

Lower mount bracket – 20” Models

Share on social:

Produtos Relacionados