PREPARE-SE PARA O INVERNO: de 10 % a 50 % de desconto em todas as peças OEM!

A menos que seja proibido pelo fabricante. Não inclui produtos de reposição ou da marca Crowley Marine. Preço conforme marcado.

Os nossos armazéns encerram na quinta-feira, 26, e na sexta-feira, 27 de novembro. Feliz Dia da Thanksgiving dos Estados Unidos!

Contate-Nos
Procure por Mais de 1 Milhão de Peças Originais
Fáceis de usar  diagramas de peças Melhor preço  de garantia Especializado  suporte ao vivo Mais de 50 anos  servindo velejadores Enorme seleção de peças OEM  -  de 1950 a 2026 A maioria das peças em estoque  -  Cumprimento no mesmo dia
Peças em estoque- Realização no mesmo dia

Service Manual 200-300 HP E-TEC Maintenance [Anti-Corrosion Protection]

Produtos Relacionados:
Service Manual 200-300 HP E-TEC Maintenance [Anti-Corrosion Protection]
5007820
BRP Marine

Sacrificial Anodes

Galvanic corrosion occurs in fresh or salt water. Salt, brackish, and polluted water can accelerate corrosion. “Sacrificial” anodes are intended to protect the underwater metal components of the outboard from galvanic corrosion.

Outboards are equipped with three sacrificial anodes.


DR5082

  1. Stern bracket anode
  2. Propeller shaft bearing housing anode (inside of gearcase housing)
  3. Gearcase housing anode

Visually inspect anodes and metal components below water level. Erosion of anodes is normal and indicates the anodes are functioning properly.

IMPORTANT: Anodes that are not eroding may not be properly grounded. Anodes and the mounting screws must be clean and tight for effective corrosion protection.

For best anode performance:

• Replace all anodes that have eroded or disintegrated to two-thirds of their original size.
• Do not paint or apply protective coatings to anodes or anode fasteners.
• Avoid using metal-based antifouling paint on the boat or outboard.

Testing Procedure-Continuity

Connect ohmmeter leads between engine ground and anode surface.


000677

  1. Meter lead to anode

The meter should show little or no resistance. If resistance is high, check the following:

• Remove the anode and clean the area where the anode is installed.

• Clean the mounting screws.

• Install the anode and test again.

Metallic Component Protection

Protect metal components on outboards from corrosion. Use the following products to minimize corrosion.

• Anti-Corrosion Spray provides a heavy, waxy coating to protect components.

• “6 in 1” Multi-Purpose Lubricant provides a thin film of anti-corrosion protection.

Exterior Finishes

Maintain the outboard’s exterior finish to prevent corrosion and reduce oxidation.

• Use automotive wax to protect the outboard’s exterior finish from oxidation.

• Clean regularly using clean water and mild detergent soap.

• Touch-up damage to painted surfaces promptly.

• Protect moving components with appropriate lubricants.

Share on social:

Produtos Relacionados