PREPARE-SE PARA O INVERNO: de 10 % a 50 % de desconto em todas as peças OEM!

A menos que seja proibido pelo fabricante. Não inclui produtos de reposição ou da marca Crowley Marine. Preço conforme marcado.

Os nossos armazéns encerram na quinta-feira, 26, e na sexta-feira, 27 de novembro. Feliz Dia da Thanksgiving dos Estados Unidos!

Contate-Nos
Procure por Mais de 1 Milhão de Peças Originais
Fáceis de usar  diagramas de peças Melhor preço  de garantia Especializado  suporte ao vivo Mais de 50 anos  servindo velejadores Enorme seleção de peças OEM  -  de 1950 a 2026 A maioria das peças em estoque  -  Cumprimento no mesmo dia
Peças em estoque- Realização no mesmo dia

Owner's Manual DF90A, DF70A Motor Removal And Transporting

Produtos Relacionados:
Owner's Manual DF90A, DF70A Motor Removal And Transporting
99011-87L02-03A
Suzuki Marine

MOTOR REMOVAL AND TRANSPORTING

MOTOR REMOVAL

If it is necessary to remove the outboard motor from your boat, we recommend that you ask your authorized Suzuki Marine Dealer to do the work for you.

MOTOR TRANSPORTING

When transporting the motor, place the motor either vertically or horizontally.

Vertical transport:

Attach the clamp bracket to a stand by securing two transom bolts.

Horizontal transport:

  1. Drain the engine oil. Refer to the ENGINE OIL section.

  2. Drain the gasoline from the vapor separator as follows:

(1) Remove the motor cover.

(2) Remove the side cover rubber (1) from the side cover. Remove the side cover bolts and side cover.

(3) Pull the drain hose end (2) out. Loosen the vapor separator drain screw (3), and drain the gasoline into a suitable container.

Gasoline is extremely flammable and toxic. It can cause a fire and can be hazardous to people and pets. Use a proper, safe container to store any gasoline drained from the outboard motor. Keep gasoline away from sparks, flames, people, and pets.

(4) After draining, retighten the screws (3).

(5) Install the side cover and side cover rubber.

(6) Install the motor cover.

  1. Rest the motor on a case protector with the port side downwards as shown.

If you are not careful when resting the outboard on its side and do not take proper precautions such as first draining the engine oil and cooling water completely, damage can occur. Engine oil may enter the cylinder from the sump, water may enter the cylinder through the exhaust port, or the outer casings may be damaged. Always drain the engine oil and cooling water completely before laying the motor on its side, and be careful laying the motor down.

If you let the lower unit of your outboard sit higher than the power head during transporting or storing, water may trickle
into the power head, causing damage to the engine. Never let the lower unit sit higher than the power head when transporting or storing
your outboard.

TRAILERING

When trailering your boat with the motor attached, keep the motor in the normal operating position unless there is not enough ground clearance. If you need more ground clearance, trailer the motor in a tilted position using a transom saver bar or similar device to support the weight of the motor.

If you use the tilt up lock arm to hold the motor in the fully tilted up position when trailering the boat, towing motion or poor road surfaces may cause unexpected tilt lock release, resulting in damage to the motor and the tilt lock mechanism.
Never use the tilt up lock arm to hold the motor in the fully tilted up position when trailering the boat. Use a transom saver bar or similar device to support the weight of the motor.

Share on social:

Produtos Relacionados