PREPARE-SE PARA O INVERNO: de 10 % a 50 % de desconto em todas as peças OEM!

A menos que seja proibido pelo fabricante. Não inclui produtos de reposição ou da marca Crowley Marine. Preço conforme marcado.

Os nossos armazéns encerram na quinta-feira, 26, e na sexta-feira, 27 de novembro. Feliz Dia da Thanksgiving dos Estados Unidos!

Contate-Nos
Procure por Mais de 1 Milhão de Peças Originais
Fáceis de usar  diagramas de peças Melhor preço  de garantia Especializado  suporte ao vivo Mais de 50 anos  servindo velejadores Enorme seleção de peças OEM  -  de 1950 a 2026 A maioria das peças em estoque  -  Cumprimento no mesmo dia
Peças em estoque- Realização no mesmo dia

Owner's Manual DF70, DF60 Diagnostic System

Produtos Relacionados:
Owner's Manual DF70, DF60 Diagnostic System
99011-99E06-03A
Suzuki Marine

DIAGNOSTIC SYSTEM

If abnormal conditions exist in any sensor signal being sent to the control unit, the self-diagnostic system warns of the abnormal condition .

TILLER HANDLE MODEL

If this system activates, the buzzer will begin a series of short (0.2 second) beep.

REMOTE CONTROL MODEL

If this system activates, the red CHECK ENGINE lamp will flash and a buzzer will sound.

Also incorporated is a fail—safe provision that al- lows the operation at a restricted speed even under such a failure condition.

• The CHECK ENGINE lamp will light briefly when the ignition key is turned to the “ON” position.
• The failed system can be identified by the mode of the red CHECK ENGINE lamp flash- ing and buzzer sounding (Only buzzer sound- ing for the tiller handle model).
This diagnostic code is designed to appear while the ignition key is turned on.
•The buzzer sound with diagnostic system ao- tivating will be canceled by pushing the igni-tion key in. (Remote control model)

If the diagnostic system activates while you are operating your outboard motor, you should consult your authorized Suzuki Marine Dealer for repair of the control system.

OIL CHANGE REMINDER SYSTEM

This system informs the operator of the time for replacing engine oil on the basis of the mainte-nance schedule, The system is designed to register the total op-erating hours of the outboard motor and func-tion its operation when the preprogrammed hours have reached. (Refer to the INSPECTION AND MAINTE- NANCE section and the last page.)

SYSTEM ACTIVATION

TILLER HANDLE MODEL
When the total operating hours have reached the preprogrammed hours, the buzzer will be- gin a series of double beeps (3 times). This in- dication will repeat until you cancel the system activation.

REMOTE CONTROL MODEL

When the total operating hours have reached the preprogrammed hours, the OIL lamp will flash. If the engine is not running, the buzzer will begin a series of double beeps additionally.
This indication will repeat until you cancel the system activation.

CANCELLATION

  1. Turn the ignition key to the “ON" position.
  2. Pull out the emergency stop switch plate(1) .
  3. Pull up the emergency stop switch knob (2) three times in 10 seconds. A short beep will be heard it the cancellation is successfully finished.

  1. Turn the ignition key to the “OFF“ position.
  2. Set the plate(1)in the original position.
Share on social:

Produtos Relacionados