ATUALIZAÇÃO COVID-19: Como Crowley Marine está se preparando e respondendo. Consulte Mais informação...
envio $3,95 dentro
Minha Conta
Status do Pedido
Crowley Marine: servindo velejadores há mais de 50 anos Crowley Marine: servindo velejadores há mais de 50 anos
Peças em estoque Peças em estoque Realização no mesmo dia
$3.95 Enviamos todos os pedidos*
Garantia de Preço Baixo
9.6 Pilot logo
0Meu carrinho

Selecione o Seu Motor:


Fabricante BRP Marine
Tempo de Reparo 1 to 2 hours
Dificuldade de Reparo Easy
Sections 1


Use this instruction sheet when installing a replacement oil pump and manifold on 2007 and prior Evinrude® E-TEC® outboards, 40–90 HP. DO NOT install on any other models

Ref. P/N Name of Part Qty
1 5007476 PUMP & MANIFOLD Assy, 40-60 HP 1
1 5007477 PUMP & MANIFOLD Assy, 75-90 HP 1
2 351416 *SEAL 1
3 351159 CLAMP (60.5 mm) 2


When installing this oil pump on 2007 and prior models, EMM programming MUST be updated with the enclosed Service Update software to enable the LOW OIL and NO OIL warnings.

To begin the update process, use diagnostic interface cable, P/N 0437955, to connect a laptop computer to the engine diagnostic connector. Turn the key switch ON.

DO NOT run the Evinrude Diagnostic software program while performing this update.

Insert the update disc into the computer. The first update screen should appear. If the update does not start automatically, navigate to the CD in the computer’s file system and double-click the “InlineOilUpdate” icon.

Click the “NEXT” button.

When the second screen appears, click the “CONNECT” button.

The program will communicate with the EMM to check the model number, serial number, and software version.

If the update was previously installed, or is not intended for this engine, the following message will appear: Engine not qualified for update.

If the engine is qualified, click the “NEXT” button to continue.

Follow, in order, the five steps on the screen:

  • Turn the key switch OFF.

  • Install the Bootstrap tool into the key switch harness.

  • Turn the key switch ON.

  • Click the “CONFIRM BOOTSTRAP” button.

  • Click the “UPLOAD” button.

A progress bar will confirm the software upload.

When the upload is complete:

  • Click the “OK” button.

  • Turn the key switch OFF.

  • Remove the Bootstrap tool.

5007476 - KIT AY,OIL PUMP-I2