PREPARE-SE PARA O INVERNO: de 10 % a 50 % de desconto em todas as peças OEM!

A menos que seja proibido pelo fabricante. Não inclui produtos de reposição ou da marca Crowley Marine. Preço conforme marcado.

Os nossos armazéns encerram na quinta-feira, 26, e na sexta-feira, 27 de novembro. Feliz Dia da Thanksgiving dos Estados Unidos!

Contate-Nos
Procure por Mais de 1 Milhão de Peças Originais
Fáceis de usar  diagramas de peças Melhor preço  de garantia Especializado  suporte ao vivo Mais de 50 anos  servindo velejadores Enorme seleção de peças OEM  -  de 1950 a 2026 A maioria das peças em estoque  -  Cumprimento no mesmo dia
Peças em estoque- Realização no mesmo dia

Electrical System [Lower Unit And Related Parts] [1986]

Produtos Relacionados:
Electrical System [Lower Unit And Related Parts] [1986]
LIT-18616-00-06
Yamaha Marine

Choke solenoid

  1. Disconnect the choke solenoid leads from the choke solenoid and wire harness.
  2. Check the choke solenoid as specified using the pocket tester.

Continuity.................................Normal
Discontinuity.............................Defective

  1. If the element is broken, replace the entire unit.

Installation

Refer to page 4-41.

Power trim and tilt motor

Removal
Refer to page 5-18.

Disassembly

  1. Loosen the wire harness bolt, and remove the two bolts securing the frame end.
  2. Remove the commutator end by tapping on it with a plastic hammer.

1. Remove the lead wire while taking care not to break it.
2. Spray WD-40 on the lead, so the frame can easily be removed.

  1. Wire harness bolt
  2. Commutator end
  1. Remove the brushes from the brush holder, and by tapping the frame end with a plastic hammer, remove the frame end.
  2. Remove the armature from the frame end.

  1. Armature
  2. Frame end

INSPECTION AND REPAIR

Armature

  1. Check surfaces of the commutator. Using sandpaper (#500 or #600), smooth out any rough surface. If roughened excessively, turn the commutator in a lathe. If its run-out is 0.2 mm (0.008 in) or more, take the same step.
  2. Measure the commutator mica undercut. If the depth is 0.2 mm (0.008 in) or less, cut it to the specification.

Under cut: 0.4 ~ 0.8 mm (0.015 ~ 0.03 in)

  1. Check continuity between the armature coil and ground.
    If there is continuity, the armature coil is grounded and therefore, it should be replaced.
Share on social:

Produtos Relacionados