PREPARE-SE PARA O INVERNO: de 10 % a 50 % de desconto em todas as peças OEM!

A menos que seja proibido pelo fabricante. Não inclui produtos de reposição ou da marca Crowley Marine. Preço conforme marcado.

Os nossos armazéns encerram na quinta-feira, 26, e na sexta-feira, 27 de novembro. Feliz Dia da Thanksgiving dos Estados Unidos!

Contate-Nos
Procure por Mais de 1 Milhão de Peças Originais
Fáceis de usar  diagramas de peças Melhor preço  de garantia Especializado  suporte ao vivo Mais de 50 anos  servindo velejadores Enorme seleção de peças OEM  -  de 1950 a 2026 A maioria das peças em estoque  -  Cumprimento no mesmo dia
Peças em estoque- Realização no mesmo dia

Electrical System [Ignition Control System] [1998]

Produtos Relacionados:

Applicable Models

Model group Year Model Serial
Yamaha International 1998 25hp All
Yamaha Outboard 1998 25hp All

Electrical System [Ignition Control System] [1998]
LIT-18616-01-77
Yamaha Marine

IGNITION CONTROL SYSTEM (E, ET)

(1) Pulser coil
(2) Oil pressure switch
(3) Engine temperature sensor
(4) Low-oil-pressure warning lamp
(5) CDI unit

B : Black
Br : Brown
P : Pink
R : Red
W : White
Br/B : Brown/Black
P/W : Pink/White
R/W : Red/White
Y/R : Yellow/Red

IGNITION CONTROL SYSTEM (EH, EHT)

(1) Pulser coil
(2) Oil pressure switch
(3) Engine temperature sensor
(4) Low-oil-pressure warning lamp
(5) CDI unit

B : Black
Br : Brown
P : Pink
R : Red
W : White
Br/B : Brown/Black
P/W : Pink/White
R/W : Red/White
Y/R : Yellow/Red

PULSER COIL

Refer to "IGNITION SYSTEM".

OIL PRESSURE SWITCH

  1. Measure:
    • Oil pressure switch continuity
    Out of specification -> Replace

Mity Vac: YB-35956/90890-06756

Oil pressure switch continuity pressure

15.5 kPa (1.55 kg/cm2,2.25 psi) and above No continuity
15.5 kPa (1.55 kg/cm2, 2.25 psi) and below Continuity

ENGINE TEMPERATURE SENSOR

  1. Measure:
    • Output voltage (at the specified temperature)
    Out of specification -> Replace.
    Refer to the following chart.

LOW-OIL-PRESSURE WARNING LAMP

  1. Check:
    • LED (Light emitting diode) lighting
    No lighting -> Replace.

Battery voltage: 1.5 V

Yellow/Red lead -> Positive terminal.
Pink/White lead -> Negative terminal.

Use a conventional AA penlight battery (1.5 V). An alkaline or higher voltage battery can burn out the diode.

LED has a direction for electrical current. Therefore try reverse connection if there is no lighting.

Share on social:

Produtos Relacionados