PREPARE-SE PARA O INVERNO: de 10 % a 50 % de desconto em todas as peças OEM!

A menos que seja proibido pelo fabricante. Não inclui produtos de reposição ou da marca Crowley Marine. Preço conforme marcado.

Os nossos armazéns encerram na quinta-feira, 26, e na sexta-feira, 27 de novembro. Feliz Dia da Thanksgiving dos Estados Unidos!

Contate-Nos
Procure por Mais de 1 Milhão de Peças Originais
Fáceis de usar  diagramas de peças Melhor preço  de garantia Especializado  suporte ao vivo Mais de 50 anos  servindo velejadores Enorme seleção de peças OEM  -  de 1950 a 2026 A maioria das peças em estoque  -  Cumprimento no mesmo dia
Peças em estoque- Realização no mesmo dia

Bracket Unit [Swivel Bracket And Steering Arm] [2004]

Produtos Relacionados:

Applicable Models

Model group Year Model Serial
Yamaha International 2004 60hp All
Yamaha Outboard 2004 60hp All

Bracket Unit [Swivel Bracket And Steering Arm] [2004]
LIT-18616-FT-60
Yamaha Marine

Swivel bracket and steering arm

No. Part name Q’ty Remarks Tightening torques Tightening torques Tightening torques Tightening torques
Stage N-m kgf-m ft-lb
1 Steering arm 1
2 Washer 1
3 Bushing 1
4 O-ring 2 Not reusable
5 Bushing 2
6 Swivel bracket 1
7 Bushing 1
8 Port tilt stop lever 1
9 Circlip 1
10 Steering yoke 1
11 Bushing 1
12 Bushing 1
13 Tilt stop lever joint 1
14 Spring holder 1
15 Bolt 1 M6 x 10 mm
16 Spring 1
17 Bushing 1
18 Pin 2
19 Bushing 1
20 Starboard tilt stop lever 1

Removing the steering arm

  1. Remove the circlip (1).

  2. Remove the steering yoke (2) by striking it with a plastic hammer.


S62Y7380

  1. Remove the steering arm from the swivel bracket by pulling the arm off the bracket.

Installing the steering arm

  1. Install the washer (1), bushing (2) O-ring (3) and bushing (4)onto the steering arm (5).

  2. Place the swivel bracket (6)in an upright position, and then install the steering arm onto the swivel bracket.


S62Y7390

  1. Install the bushing(7), O-ring (8), and bushing (9) onto the swivel bracket.


S62Y7400

  1. Install the steering arm( 5) into the steering yoke(10) by aligning the center (a) of the yoke with the center(b)of the steering arm.

5.Install the circlip (11).


S62Y7410

  1. Inject grease into the grease nipple until grease comes out from both the upper and lower bushings (c).


S62Y7420

Share on social:

Produtos Relacionados