PREPARE-SE PARA O INVERNO: de 10 % a 50 % de desconto em todas as peças OEM!

A menos que seja proibido pelo fabricante. Não inclui produtos de reposição ou da marca Crowley Marine. Preço conforme marcado.

Os nossos armazéns encerram na quinta-feira, 26, e na sexta-feira, 27 de novembro. Feliz Dia da Thanksgiving dos Estados Unidos!

Contate-Nos
Procure por Mais de 1 Milhão de Peças Originais
Fáceis de usar  diagramas de peças Melhor preço  de garantia Especializado  suporte ao vivo Mais de 50 anos  servindo velejadores Enorme seleção de peças OEM  -  de 1950 a 2026 A maioria das peças em estoque  -  Cumprimento no mesmo dia
Peças em estoque- Realização no mesmo dia

Bracket Unit [Steering Handle] [2008]

Produtos Relacionados:

Applicable Models

Model group Year Model Serial
Yamaha International 2001 - 2005 4hp All
Yamaha Outboard 1999 - 2005 4hp All

Bracket Unit [Steering Handle] [2008]
LIT-18616-01-79
Yamaha Marine

EXPLODED DIAGRAM

REMOVAL AND INSTALLATION CHART

Step Procedure/Part name Q'ty Service points
STEERING HANDLE REMOVAL Follow the left "Step" for removal
Carrying handle 2 (protector)
Bottom cowling 2
Carrying handle 1
Engine stop switch lead NOTE: Disconnect from the power unit side.
Choke wire
Throttle cable
Bottom cowling 1
1 Bolt (steering bracket) 2
2 Steering bracket 1
3 Dowel pin 1

EXPLODED DIAGRAM

Step Procedure/Part name Q'ty Service points
4 Bolt (steering handle ass'y) 1
5 Steering handle cover 1
6 Collar 1
7 Plate washer 1
8 Steering handle ass'y 1
9 Collar 1
10 Rubber bushing 1
Reverse the removal steps for installation.

SERVICE POINTS

Rubber bushing installation

  1. Install:
    • Rubber bushing

• Align the projection (a) on the pressure fit side of the rubber bushing flange with the projection (b) on the steering bracket.
• Push the rubber bushing on its inner cylinder in the direction of the arrow as shown and pressure fit it into the steering bracket.
• After fitting it, check that there is no clearance between the bushing flange and the steering bracket end (c).

Throttle cable installation

  1. Install:
    • Throttle cable

The throttle cable should be routed through the cut (a) in the steering handle cover with the outer tube end (b) in contact with the step (c) in the steering handle.

EXPLODED DIAGRAM

REMOVAL AND INSTALLATION CHART

Step Procedure/Part name Q'ty Service points
STEERING HANDLE DISASSEMBLY Follow the left "Step" for disassembly.
Steering handle ass'y
(1) Metal washer 2
(2) Wave washer 1
(3) Collar 1
(4) Cotter pin 1
(5) Friction adjusting screw 1
(6) Screw 1
(7) Steering grip 1
(8) Washer 1

EXPLODED DIAGRAM

Step Procedure/Part name Q'ty Service points
(9) Spring 1
(10) Bushing 1
(11) Bolt 2
(12) Plate 1
(13) Throttle shaft 1
(14) Friction piece 1
(15) Throttle cable 1
(16) Steering handle 1
Reverse the disassembly steps for assembly.
Share on social:

Produtos Relacionados