Fuel Injector Assembly (Port) 5007764
Last update: 21 days ago Update Now View Secondary Warehouses
This product is not being produced anymore however may still be available through other dealers.
Last search: 21 days ago Update Now
No searched locations carry this part.
There are no questions for this product. Ask a new question and receive an answer, directly from our support staff.
300 Evinrude's Etec
- Repair Difficulty
- Repair Time
- 1 to 2 hours
Problem fixed: Hard starting on Starboard engine and engine stumble or stutter above 3000rpm on the port engine
Diagnosed injectors using Evinrude's Diagnostic software. I was able to isolate the injector by shutting down each injector one at a time until the stutter quit on the port engine. On the starboard side I was able to use a similar technique by getting the engine started the disabling the idle control with the soft ware and the shutdown one at a time until I saw no change as a result of turning the injectors off. I had one injector on that engine that would not fire below 1000 rpm. I actually replaced three injectors the third I replaced because it was very noisy and changed it as a precaution.
Evinrude etec 115 fuel injector
Product Fitment Grid
This guide is to be used as a reference only. You must verify fitment using your model or serial number.
Customers Also purchased
Fill & drain Plug Drain Screw
Fuel Injector Seal Kit
Fuel Starboard Injector Assembly
SPK PLUG QC10WEP
Water Pump Repair Kit (Includes Impeller Housing)
|Fuel Injector Assembly (Port) VIEWING THIS PRODUCT||5007764||CURRENT|
|OBSOLETE BRP PART||5007318||5007764|
|Fuel Injector Assembly (Port)||5007585||5007764|