Shft Rod Connector 0303794

- This is an OEM part manufactured by Evinrude & Johnson, OMC
- Flat rate shipping starting at $4.95
- 30 day return policy
Product Questions
There are no questions for this product. Ask a new question and receive an answer, directly from our support staff.
85 Product Reviews
Johnson 9.9
- Repair Difficulty
- Medium
- Repair Time
- 30 to 60 mins
Problem fixed: low water pressure
Follow the Johnson manual. Pretty easy
1993 Evinrude 15 HP
- Repair Difficulty
- Medium
- Repair Time
- 1 to 2 hours
Problem fixed: No water flow
Removed lower unit, remove old water pump, clean up drive shaft and associated components, lubricate shaft area, install new water pump, key, and housing. Install lower unit on engine. Kind of tricky to connect the shift as the lower unit bolts must be removed then there is a coupling connecting the upper shift rod to the lower unit that must be detached (bolt removed). Keep the shift in forward position to ensure adequate spacing. Project was completed in about 2 hours, take you time it will turn out fine.
Evinrude 35
- Repair Difficulty
- Easy
- Repair Time
- 1 to 2 hours
Problem fixed: Gear ox shift linkage was broken
I opend up the gearbox, drained all the oil saw what my problem was then ordered the part, removed the old broken part and replaced it by the new one
28 hp evenrude
- Repair Difficulty
- Easy
- Repair Time
- 30 to 60 mins
Problem fixed: Shift arm
Replace worn shift rod connector
Evinrude 10424s 9.9
1967 evinrude 6 hp
Johnson 10hp
9.9 johnson
1986 Evinrude 15
- Repair Difficulty
- Easy
- Repair Time
- Less than 30 mins
2010 30 hp Etec
Johnson 9.9
E10RCCD
Johnson 28 hp
- Repair Difficulty
- Easy
- Repair Time
- Less than 30 mins
ETEC 30
- Repair Difficulty
- Medium
- Repair Time
- 2 to 4 hours
Problem fixed: Water pump replacement
Repair was going great until water tube became disconnected from upper connection point on powerhead..tube would not slip out from pump housing .. so.. exhaust and other things needed to be removed.. not too bad , just frustrating. Upon re assembly anti seize was applied to pump housing grommet to prevent this next time
Johnson 9.9 horsepower model year 2000
- Repair Difficulty
- Medium
- Repair Time
- 2 to 4 hours
Problem fixed: Had to replace water pump
Had replace a water-pump couple of months ago and ran it dry just checking if it would start after installing new spark plugs when I hooked up the muff later to do some tuning it didn't pump water disassembled check the pump couldn't find anything wrong with it ordered a new pump found that when I had assembled the pump a couple months ago that the connector of the shift rod between the upper unit in the lower unit had a stripped nut I went online looking for the connector and bolts and found Crowley Marine, found the parts list for my motor was able to order the parts and they were shipped promptly and I was able to reassemble the unit although had difficulty aligning the connector. This the 2-4 he time trying to get it back together I finally was able to do so and everything's working fine the water pump is working I will never start that motor dry again if I need any more parts for that motor or any other motor I will definitely go through Crowley Marine they have just about anything you need
1987 Evinrude 28 hp
- Repair Difficulty
- Medium
- Repair Time
- 2 to 4 hours
Problem fixed: All went well pumps water and runs great.
Parts dead on.
Evenrude 15 hp
- Repair Difficulty
- lProfessional
- Repair Time
- More than 4 hours
Problem fixed: Transom movement, water pump old, and would not run without the choke being partially open,
Complete disassembly to rebuild water pump, carburetor, and replace transom mount bushings, then re assemble motor.
Johnson 9.9
- Repair Difficulty
- Medium
- Repair Time
- 1 to 2 hours
Problem fixed: Water pump replacement
Remove 6bolts that holds bottom part of motor, place motor in foward gear, bottom will drop down, you will see a brass block with two bolts, undo top bolt and remove, pull bottom away. Remove old pump and clean surface area, place assembled pump over shaft ensuring you use gasgat cement not only on the plate but on the pump also. Look out for the little pin is in the right position, tighten and replace bottom back on main body, bolt brass block to rod, turn motor to allow shaft to fit in replace bolts and test. if in doubt look up Google on how to replace. Good luck.
Evinrude 15hp
- Repair Difficulty
- Easy
- Repair Time
- Less than 30 mins
Problem fixed: fuel tank leaking
right parts,fast shipping
johnson 15
60 HP
Evenrude 15hp (2) motors
- Repair Difficulty
- Easy
- Repair Time
- More than 4 hours
Problem fixed: Retrofit
Changing from rubber mounted prop to a more solid- more dependable mount, prop spin with older props is a real problem...but not any more!!
Johnson 9.9 and Johnson 15
Evinrude 1975, 9.9, model 10524C .
- Repair Difficulty
- lProfessional
- Repair Time
- More than 4 hours
Problem fixed: Complete work over.
From ignition points, coils, water pump, shifting connections, lower unit seals, missing idle and lean/rich knobs, throttle gears, thermostat, gaskets and a carb. rebuild kit, etc .
Johnson 9.9 hp
Johnson 9.9 1986
- Repair Difficulty
- Easy
- Repair Time
- 30 to 60 mins
Problem fixed: Water pump and crank rod linkage
Replace water pump. U tube video
evinrude E15EETB
E15BA 1980
Johnson 25 hp
1986 Johnson 15 HP.
Johnson 9.9
Evinrude BRP, Etech 30
- Repair Difficulty
- Easy
- Repair Time
- Less than 30 mins
1958 Evinude 18 HP
Customers Also purchased

Bearing Housing to Propeller Shaft Oil Seal
0321481
Gearcase to driveshaft Z Oil Seal
0321480Parts included in this kit
Please note: Some of the included items may not be available for purchase separately and won't be listed here.
Name | SKU | Price | Brand |
---|---|---|---|
Exhaust Seal | 0326922 | Evinrude & Johnson, OMC | |
Extension | 0319340 | Evinrude & Johnson, OMC | |
Gearcase Extension Assembly | 0331152 | Evinrude & Johnson, OMC | |
Impeller Housing Seal | 0319085 | Evinrude & Johnson, OMC | |
Lock Washer | 0301551 | Evinrude & Johnson, OMC | |
Screw | 0341206 | Evinrude & Johnson, OMC | |
Water Tube Extension O-Ring (5" Longer Models) | 0202893 | Evinrude & Johnson, OMC | |
Water tube 20 INCH | 0320025 | Evinrude & Johnson, OMC |
Supersession Chain
Name | SKU | Superceding SKU |
---|---|---|
Shft Rod Connector VIEWING THIS PRODUCT | 0303794 | CURRENT |
SHIFT SHAFT CONNECTOR | 0766409 | 0303794 |