flat $4.95 shipping
My Account
Order Status
Crowley Marine: serving boaters for over 50 years
Parts in stock Most parts in stock Same day fulfillment
$4.95 shipping on all orders*
Low Price Guarantee
9.6 Pilot logo
0My cart

Select Your Engine:

Johnson/Evinrude, OMC

Bushing 0301877

Satisfaction rating 5 out of 5 (74 Ratings)
$3.95
You save $.14. (3%) $4.09
5+ IN STOCK Ships Immediately
  • This is an OEM part manufactured by Johnson/Evinrude, OMC
  • Flat rate shipping starting at $4.95
  • 30 day return policy

Product Description

Bombardier factory part. Search for more factory parts & parts diagrams.

Product Questions

There are no questions for this product. Ask a new question and receive an answer, directly from our support staff.

74 Product Reviews

johnson 30 hp

Repair Difficulty
Hard
Repair Time
1 to 2 hours
good
by

Problem fixed: shift shaft bushing leaking

had to tap bushing with 5/16 x 18 tap and screw in 5/16 all thread with nut and plate and wind up bushing.Open to any other ideas.

GREAT
by

Johnson 35 seahorse

Repair Difficulty
Medium
Repair Time
More than 4 hours
Great, ordered several times, quick shipping, good service. Only 1 mistake ever and it was fixed immediately.
by

Problem fixed: Vacuum leaks, blown head gasket, exhaust leaks, lower unit water leak.

Remove, starter, carburetor, fuel pump, coils, sparkplugs. Remove throttle and shift linkage, unhook hoses and grounds. Pull powerhead. Pull head, water jacket cover, exhaust cover; I broke a bolt ☹, remove, intake cover, intake manifold, Reed valves. Inspect bearings, crankshaft, pistons and rings; all in amazing good shape. 👍. Replace upper and lower oil seals and lower o ring. All gaskets clean to bare Shiney metal on all surfaces. At this point I had to repair the broken bolt, I broke off an extract tool inside it after drilling, had to weld a nut on to get it out. Had to jb weld repair the case and retap the hole. Then gasket seal when needed and replaced all gaskets. Then 4 oil seals on lower end 3 o rings and install chrome water pump. Now I'm working on new wiring and ignition.

No call or email they were waiting so long on my parts. I called and they said it would ship soon. Waited another week and called and they were waiting on 2 parts out of a ton of parts. I asked them to ship what they had and cancel the 2 parts. Got order and still missing 1 part. I found parts all over that arrived before all parts I had been waiting on for about 24 days!!
by

by

95 Evinrude 9.9

Over all a good experience! I will return for more parts when needed!
by

Very good store, helpful and professional staff. Quick response. I ordered some parts and need some more, I send email to add new parts to my order, they did that immediately . Thank you very much for your good service. Highly recommended this store.
by

by

by

by

They make it a easy way to shop so I can get back on the water! I give em 👍👍& a high five:)
by

Very good
by

by

Repair Difficulty
Easy
Repair Time
Less than 30 mins
by

Problem fixed: Lower unit leaking gear oil.

I removed the four bolts (7/16 wrench) that holds the lower unit gear box on. I then took the lower gear box apart taking the six screws out and then I could take the shifting rod off and slide it out of the bushing where my leak is. I took a 5/16 tap and tapped the hole where the shifting rod goes thru, then with a 5/16 bolt and a socket I made a puller to extract the bushing to replace the o ring that is behind it where the leak originated. Dave

by

Very good, the carb kit I ordered has my 6HP johnson running like brand new. Thanks again, Tony
by

by

by

Excellent customer service even with COVID screwing things up Highly recommended. Their parts diagrams are the best I’ve seen as well
by

good service. fast shipping.
by

Great. I have not received my items yet but am sure they will arrive soon.
by

Evinrude 30 hp

Repair Difficulty
Hard
Repair Time
1 to 2 hours
by

Problem fixed: Lower unit taking on water

Rebuilt entire lower unit

Evinrude 30

Very easy to find whats needed...
by

Was a great experience. Will make a future purchase
by

Great! Customer service was apologetic and sent the item my order was missing (an o-ring) the day I notified them of the problem. Thank you!
by

It was very good!
by

by

Excellent. My order arrived later than I expected but it was because we had very serious bush fires in our area and the mail was not able to be delivered. My inquiry was answered promptly. Very pleased.
by

Overall my experience was good. I ordered a few parts off of the parts diagram for my 1965 6hp Johnson. However, one of the "part numbers" was for the pull start cord, so I ordered one of those as well. When my order arrived I found a completely useless 1 foot piece of start cord in a bag. I can only guess that the intention was to order this by the foot but that was not marked at all on the site and the fact that someone at Crowley actually cut a 12 inch piece and included it in my order is ridiculous.
by

Good
by

Johnson 25 hp

Great service . Quick and easy to deal with
by

by

OMC Saildrive 15HP 1984

Repair Difficulty
Medium
Repair Time
More than 4 hours
Did get the parts I needed for my OMC saildrive. Prices are reasonable. The parts I needed are for an impeller and seals replacement. I have the famous water in the lower cylinder.
by

Problem fixed: Water in lower cylinder and low flow from exhaust.

Have not started it but I expect it will not be easy on my S2 8.0 sailboat.

83' Johnson 35hp

Repair Difficulty
Medium
Repair Time
2 to 4 hours
by

Problem fixed: It seems to be kicking out of gear under a load but not at trolling speed

Rebuild the lower end, new deals, bushings, and seals. Only real noticeable issue was with the clutch dog. It had wear on the dogs like it was climbing out of the gear so I replaced that and also machined the forward gear so the new one will seat better since it also showed a little rounding on the top edge where it appears the clutch dog was climbing out. Unfortunately at this point I'm waiting for a new water pump kit to test it since it appears that I lost the keeper for the shaft to the impeller.

1965 Johnson 9.5

Repair Difficulty
Medium
Repair Time
2 to 4 hours
I had a payment problem. I used a wrong card. The next day I called and talked to a man that helped me get everything corrected.
by

Problem fixed: Leaks oil

Seals and oil seals were all hard. Resealed the lower unit

1958 Evinrude 5.5hp

Very good communication and customer service. Multiple emails about order and delivery status to help me track the order. Shipping was very quick to Canada. This will be my go-to supplier for OMC outboard parts.
by

by

by

by

1999 Johnson 35hp outboard

Repair Difficulty
Easy
Repair Time
Less than 30 mins
by

Problem fixed: Overheat buzzer goes off at times

Replaced thermostat. Very easy. Can do while in the water. Only needed a crescent wrench to remove the cover for the old one. Reused the springs and gaskets. No more overheat buzzer.

1981 Evinrude 15 hp

Repair Difficulty
Medium
Repair Time
1 to 2 hours
Great. I have now completed my 15 hp Evinrude restoration project.
by

Problem fixed: Lower end seals leaking.

Rebuilt water pump, installed new seals in lower end including new shift rod bushing and seal.

by

My experience has been excellent. I am rebuilding the lower unit of a 1984 Johnson 25 hp outboard. It is badly worn and I have needed many different parts. This is the second, but not the last, order I have put in. Crowley has had everything I've needed and shipment has usually taken just a few days. I have been notified of back-ordered parts and they have all come in just a few days later.
by

Everything was great, timely. Thanks.
by

by

johnson 28

Repair Difficulty
Easy
Repair Time
1 to 2 hours
excellent had no problems and every thing was what I ordered
by

Problem fixed: new water pump

went fine and fixed the problem

by

by

by

by

!977 35 hp Evinrude

by

by

Johnson 33 hp

by

by

Trouble free great service.
by

Efficient sales associate. Parts were as advertised. Swift service. Got you bookmarked for future help.
by

Fast, excellent, accurate service. Thank you. CV
by

by

Johnson 9.9 outboard

Repair Difficulty
Medium
Repair Time
More than 4 hours
Once again Crowley Marine came through with the parts I needed for my old Johnson 9.9. I have no problem recommending Crowley to anyone.
by

Problem fixed: Low compression on one cylinder and leaky seals in lower unit.

The first plus was having the original parts and repair manuals. Slowly dismantling and tagging parts as I proceeded. I listed everything that could be replaced or refreshed and orders same. When finished I had found an weak reed valve, installed carb and water pump kits along with lower seals and numerous gaskets and gromets. Now runs like a new motor.

by

by

Johnson 30hp

Repair Difficulty
Medium
Repair Time
30 to 60 mins
Fast shipping and great price on what I needed.
by

Problem fixed: Water Pump Replacement

Needed an additional part after pulling foot. Crowley's had what I needed and shipped it fast.

Crowley Marine always comes through!
by

by

Excellent.
by

by

25 HP AND 6 HP JOHNSON

Repair Difficulty
Easy
Repair Time
30 to 60 mins
XXXXX FAST SHIPPING EASY ORDERING WITH THIS SITE GOOD INVENTORY . WILL TELL OTHERS AND BUY AGAIN.
by

Problem fixed: LOWER UNIT RESEAL ON BOTH

DROP LOWER UNIT REMOVE PUMP -SHAFT-SKEG- GEAR GROUP -SEALS . RESEAL AND REASSEMBLE . PRESSURE TEST

by

by

by

by

by

by

Thanks for the parts well worth waiting for them. Will do more business with you guys in the future. Wayne from the land down under
by

Customers Also purchased

Supersession Chain

Name SKU Superceding SKU
Bushing VIEWING THIS PRODUCT 0301877 CURRENT
O-RING 0777522 0301877

Aftermarket Product Interchange

Name SKU Price Brand
O-Ring 18-7100 $2.11 Sierra Marine