(#8-32) Set Screw 10-20518
This product is not being produced anymore however may still be available through other dealers.
- This is an OEM part manufactured by Mercury Marine
- Flat rate shipping starting at $3.95
- 30 day return policy
There are no questions for this product. Ask a new question and receive an answer, directly from our support staff.
3 Product Reviews
Mercruiser 7.4 MPI Bravo III - 310hp
- Repair Difficulty
- Repair Time
- More than 4 hours
Problem fixed: Hard shifting
The complete process of replacing the Intermediate Shift Cable is time consuming and somewhat difficult. I removed the stern drive, then removed the Intermediate Shift Cable. To install the new shift cable it had to be routed through the transom in a location which can't be seen from inside the boat and in a very small space between the rear motor mount and exhaust pipe the routing location was provided in the Mercruiser instructions - but not the method of how to accomplish the task). I used many years of experience of "fishing" wires and cables to install the shift cable, using fish tape, nylon string, mono filament fishing line and a bore scope. Installation of this one particular part, the Cable End Guide, on the shift cable, was quite simple and took only a matter of minutes. After completing the above process, I re-installed the stern drive according to Mercruiser instructions.
Customers Also purchased
Control Linkage Barrel
Shift Cable Anchor
Throttle Cable Guide
Aftermarket Product Interchange
|Anchor Screw Set||18-2303||$1.69||Sierra Marine|
|Set Screw (Min. Qty 10)||21433||$1.05||GLM Marine|