PRÉPAREZ-VOUS POUR L'HIVER : de 10 % à 50 % de réduction sur toutes les pièces d'origine !

Sauf interdiction par le fabricant. N'inclut pas les produits de rechange ou de marque Crowley Marine. Prix indiqué.

Nos entrepôts sont fermés le jeudi 26 et le vendredi 27 novembre. Joyeuse fête de Thanksgiving des États-Unis!

Recherche Plus d'un 1 million de pièces d'équipementier
Facile à utiliser  schémas des pièces Meilleur prix  garanti Assistance en directexperte   Plus de 50 ans  au service des plaisanciers Grand choix de pièces OEM  -  de 1950 à 2026 La plupart des pièces en stock  -  Exécution le jour même
Pièces en stock- Exécution le même jour

Service Manual G2 74° V6 Service Manual 5010014 Gearcase [Shift Actuator]

Produits associés:
Service Manual G2 74° V6 Service Manual 5010014 Gearcase [Shift Actuator]
5010014
BRP Marine

Shift Actuator

Control Circuit Tests

Use appropriate test leads or adapters such as Test Probe Kit, P/N 342677, when performing electrical tests.
NEVER pierce the insulation of the engine wiring, or use any piercing-style test probe. Piercing insulation damages the wire and can cause other unintended electrical problems.

Circuit tests check the integrity of the main engine harness and EMM circuits using resistance or diode tests. Continuity tests check the integrity of ground circuits and/or the 55V circuit. These tests eliminate the need to disconnect the engine harness from the EMM, or remove the EMM.

Remove the electrical connector from the shift actuator.

Make sure the key switch is OFF.

Use the diode test function of a digital multimeter to check the shift actuator circuits. Use an appropriate test probe lead to connect the negative meter lead to the wire listed in the table, connect the positive meter lead to an engine ground.

  1. Engine harness connector (shift actuator)
Shift Actuator Circuit Diode Test
Wire Pin Result
Yellow/Blue 1 approximately 0.5 VDC
Yellow/Green 2 approximately 0.5 VDC
Red/White 3 0.11 to 0.125 VDC
Yellow/Black 4 2.1± 0.5 VDC

Results:

  • No reading (OL or ∞) indicates an open circuit.
  • A reading of zero (0) indicates an short circuit. Isolate the faulty component. Check wiring and connections. Repair or replace faulty wiring.

Shift Actuator Ground Circuit

Use a digital multimeter with appropriate test probe leads to measure the ground circuit resistance. Connect the positive meter lead to the engine harness connector wire listed in the table. Connect the negative meter lead to engine ground.

Shift Actuator Ground Circuit Resistance
Wire Pin Result
Black/White 5 < 1 Ω

Results:

An infinite reading (∞) indicates an open circuit. Isolate the faulty component. Check wiring and connections. Repair or replace faulty wiring.

Neutral Circuit

There are no tests for the neutral circuit.

Share on social:

Produits associés