PRÉPAREZ-VOUS POUR L'HIVER : de 10 % à 50 % de réduction sur toutes les pièces d'origine !

Sauf interdiction par le fabricant. N'inclut pas les produits de rechange ou de marque Crowley Marine. Prix indiqué.

Nos entrepôts sont fermés le jeudi 26 et le vendredi 27 novembre. Joyeuse fête de Thanksgiving des États-Unis!

Recherche Plus d'un 1 million de pièces d'équipementier
Facile à utiliser  schémas des pièces Meilleur prix  garanti Assistance en directexperte   Plus de 50 ans  au service des plaisanciers Grand choix de pièces OEM  -  de 1950 à 2026 La plupart des pièces en stock  -  Exécution le jour même
Pièces en stock- Exécution le même jour

Service Manual DF70, DF60 Self-Diagnostic System [26][Df70, Df60]

Produits associés:
Service Manual DF70, DF60 Self-Diagnostic System [26][Df70, Df60]
99500-99E13-01E
Suzuki Marine

SELF-DIAGNOSTIC SYSTEM

The self-diagnostic system alerts the operator when an abnormality occurs in a signal from the sensor, switch, etc. When the system is activated, the “CHECK ENGINE” lamp flashes (lights intermittently) according to each code pattern along with a buzzer sound.

When the engine is running, the buzzer sounds a series of short (0.2 sec.) beeps. When the engine is not running, the buzzer sounds according to each code pattern, but not simultaneous with the lamp flash. The buzzer sound, activated by the self-diagnostic system, can be temporally canceled by pushing the ignition key in. (Remote control model only)

On the tiller handle model, alerts is signaled by a sound sequence only from the buzzer contained in the tiller handle.

PRIORITY/CODE/PATTERN FOR SELF-DIAGNOSTIC SYSTEM OPERATION

• If more than two items fail at once, the self-diagnostic indication appears according to priority order. The indication repeats three times.
• If the failed item remains, the self-diagnostic indication appears again after turning the ignition switch “ON”.
• After correcting failed item, the self-diagnostic indication appears until the ECM receives the proper signal with the engine running.
• For the cylinder temp. sensor, the exhaust manifold temp. sensor or the IAT sensor, the self-diagnostic indication will be canceled after corrective action by turning the ignition switch “ON”. (The ECM will require 10 – 20 seconds after turning the ignition switch “ON” to cancel the self-diagnostic indication.)

The self-diagnostic indication may be canceled by turning ignition switch “ON” because the ECM detects only battery voltage, not charging output. Under this condition the buzzer will not sound a 1-1 code. However, if the rectifier & regulator have failed, the self-diagnostic indication will again appear after starting the engine.

CONDITION FOR SELF-DIAGNOSTIC SYSTEM OPERATION

This condition will be caused by IAC valve failure or incorrect by-pass air screw adjustment. If IAC valve is always closed or by-pass air is too low, the ECM controls the IAC valve duty to increase to maintain the idling/trolling speed specified.

This condition will be caused by disconnected, kinked or clogged MAP sensor hose or clogged inlet maniford.

Share on social:

Produits associés