Fuel System
Precautions
Precautions on Fuel System Service
Service operation of any type performed on the fuel system involves a risk of fire and injury if proper precautions are not taken.
Be sure to take the following precautions when working around gasoline or servicing the fuel system.
• Disconnect battery cables except when battery power is required for servicing / inspection.
• Keep the working area well ventilated and away from open flame (such as gas heater) or sparks.
• Do not smoke or allow anyone else to smoke near the working areas.
Post a “NO SMOKING” sign.
• Keep a fully charged CO2 fire extinguisher readily available for use.
• Always use appropriate safety equipment and wear safety glasses when working around a pressurized fuel system.
• To avoid potential fire hazards, do not allow fuel to spill on hot engine parts or on operating electrical components.
• Wipe up fuel spills immediately.
• When disconnecting a fitting on the fuel line, cover the fitting with a shop cloth to soak up the small amount of fuel that may flow out from the disconnected fuel line. Put the used cloth in an approved container.
• Since fuel hose connections vary with the pipe type, connect and clamp each hose using the correct method for each specific connection.
After connecting a hose, check that there is no twist or kink in the hose.
• When installing hose clamps, position tabs to avoid contact with other parts.
• Be sure hoses do not contact rods, levers or other components with engine either operating or at rest.
