PRÉPAREZ-VOUS POUR L'HIVER : de 10 % à 50 % de réduction sur toutes les pièces d'origine !

Sauf interdiction par le fabricant. N'inclut pas les produits de rechange ou de marque Crowley Marine. Prix indiqué.

Nos entrepôts sont fermés le jeudi 26 et le vendredi 27 novembre. Joyeuse fête de Thanksgiving des États-Unis!

Recherche Plus d'un 1 million de pièces d'équipementier
Facile à utiliser  schémas des pièces Meilleur prix  garanti Assistance en directexperte   Plus de 50 ans  au service des plaisanciers Grand choix de pièces OEM  -  de 1950 à 2026 La plupart des pièces en stock  -  Exécution le jour même
Pièces en stock- Exécution le même jour

Service Manual DF40, DF50 Oil Change Reminder System [236][Df40, Df50]

Produits associés:
Service Manual DF40, DF50 Oil Change Reminder System [236][Df40, Df50]
99500-87J08-01E
Suzuki Marine

Step 1: OIL CHANGE REMINDER SYSTEM

This system informs the operator of the time for replacing ENGINE OIL on the basis of the recommended maintenance schedule.

When the total motor operating hours have reached the preprogrammed hours;

  • On the tiller handle model, the buzzer will begin a series of double beeps for approx. 1 minute.
  • On the remote control model, the “OIL” lamp will flash, and the buzzer will begin a series of double beeps if engine is not running (but ignition switch is ON).

The above mentioned indication will repeat until canceling system activation.

Step 2: INDICATION OF SYSTEM ACTIVATION

Tiller Handle Model

Remote Control Model

On the tiller handle model, the buzzer for system activation will first begin to sound when the engine is stopped (but ignition switch is ON) after reaching the preprogrammed hours.

Buzzer         OIL lamp

Step 3: FLOWCHART OF SYSTEM ACTIVATION AND CANCELLATION

*1 : Lapse of initial 20 hour’s operation
*2 : Lapse of 80 hour’s operation
*3 : Lapse of 100 hour’s operation
*4 : When performing cancellation before system activation

This system will activate up to 2100 hour’s operation.

Step 4: CANCELLATION

Procedure

  1. Turn the ignition key to the “ON” position.
  2. Pull out the emergency stop switch plate (1).
  3. Pull up the emergency stop switch knob (2) three times in seven seconds. A short beep will be heard if the cancellation is successfully finished.
  4. Turn the ignition key to the “OFF” position.
  5. Set the plate (1) in the original position.

• Canceling of the system activation is possible regardless of whether or not the engine oil has been replaced. Once the system has operated, however, Suzuki strongly recommends that the engine oil be replaced before canceling the system activation.
• Even if the engine oil has been replaced with the system not operating, it is still necessary to perform the cancellation.

Share on social:

Produits associés