Installation

- Remove two bolts and high pressure fuel filter (13).
- Disconnect lead wire connectors (14) from all fuel injectors.

- Remove four (4) bolts and Throttle body (15).
Remove IAC valve hose (16) from Throttle body.

- Remove bolts and nuts, and then remove intake manifold assembly (17).
INSTALLATION
Installation is reverse order of removal with special attention to the following steps.
Do not re-use gasket once removed. Always use a new gasket.
- Apply the bond to both mating surfaces of the intake manifold gasket.

99000-31140 : Suzuki Bond 1207B
- Tighten bolts and nuts securely.
Intake manifold bolt & nut :
6 mm 11N•m (1.1 kg⋅m, 8.0 lb⋅ft.)
8 mm 23N•m (2.3 kg⋅m, 16.5 lb⋅ft.)
- Check to ensure that all removed parts are back in place.
Checking
- Check fuel and water hose routing. (See page 10-7 to 10-9)
- Check wire routing (See page 10-1 to 10-6)
- Check for fuel leakage. (See page 5-3)
- Check for water leakage.
