PRÉPAREZ-VOUS POUR L'HIVER : de 10 % à 50 % de réduction sur toutes les pièces d'origine !

Sauf interdiction par le fabricant. N'inclut pas les produits de rechange ou de marque Crowley Marine. Prix indiqué.

Nos entrepôts sont fermés le jeudi 26 et le vendredi 27 novembre. Joyeuse fête de Thanksgiving des États-Unis!

Recherche Plus d'un 1 million de pièces d'équipementier
Facile à utiliser  schémas des pièces Meilleur prix  garanti Assistance en directexperte   Plus de 50 ans  au service des plaisanciers Grand choix de pièces OEM  -  de 1950 à 2026 La plupart des pièces en stock  -  Exécution le jour même
Pièces en stock- Exécution le même jour

Service Manual DF40, DF50 Inspection For Resistance [75][Df40, Df50]

Produits associés:
Service Manual DF40, DF50 Inspection For Resistance [75][Df40, Df50]
99500-87J08-01E
Suzuki Marine

INSPECTION FOR RESISTANCE

09930-99320 : Digital tester
Tester range : Ω (Resistance)

Make sure ignition switch is always OFF when measuring resistance.

(1) Disconnect battery cables from battery.
(2) Disconnect all wires from ECM.
(3) Connect the tester probes to terminal of wire harness side, and measure resistance according to the “RESISTANCE TABLE".

RESISTANCE TABLE

1: Disconnect remote control wire harness, and connect tester probe to terminal (A) (Gray wire).

OTHER INSPECTION

FUEL INJECTOR OPERATING SOUND (CRANKING)
(1) Touch a sound scope or long blade screw driver to fuel injector body as shown.
(2) Crank engine and check for injector operating sound.

Injector operating sound : “Click”

FUEL INJECTOR OPERATING SOUND (INDIVIDUAL)
(1) Disconnect fuel injector wire, and connect the test cord.

09930-89260 : Injector test cord A

(2) Connect Gray wire to body ground.
(3) Momentarily touch Black/Yellow wire to starter motor relay right terminal (connected to battery positive (+) terminal), and check for injector operating sound.

Injector operating sound : “Click”

Connecting fuel injector to battery positive for more than a few seconds may cause injector overheating and possible injector solenoid failure.

FUEL INJECTOR OPERATING SIGNAL

09930-89930 : 8-pin test cord

Peak voltmeter Stevens CD-77
Tester range : NEG5O

(1) Connect the test cord as shown, then turn ignition switch ON.
(2) Connect the tester probe (-) (Black) to starter motor relay right terminal (connected to battery positive (+) terminal) as shown.

Share on social:

Produits associés