PRÉPAREZ-VOUS POUR L'HIVER : de 10 % à 50 % de réduction sur toutes les pièces d'origine !

Sauf interdiction par le fabricant. N'inclut pas les produits de rechange ou de marque Crowley Marine. Prix indiqué.

Nos entrepôts sont fermés le jeudi 26 et le vendredi 27 novembre. Joyeuse fête de Thanksgiving des États-Unis!

Recherche Plus d'un 1 million de pièces d'équipementier
Facile à utiliser  schémas des pièces Meilleur prix  garanti Assistance en directexperte   Plus de 50 ans  au service des plaisanciers Grand choix de pièces OEM  -  de 1950 à 2026 La plupart des pièces en stock  -  Exécution le jour même
Pièces en stock- Exécution le même jour

Service Manual DF40, DF50 Inspection For Ecm Circuit Voltage [74][Df40, Df50]

Produits associés:
Service Manual DF40, DF50 Inspection For Ecm Circuit Voltage [74][Df40, Df50]
99500-87J08-01E
Suzuki Marine

INSPECTION

PRECAUTION ON SYSTEM INSPECTION

To prevent an unexpected engine start, perform the following before proceeding with any CRANKING tests.
• When performing tests not related to fuel injector operation :
  • Disconnect all fuel injector wire connectors.
• When performing tests related to fuel injector operation :
  • Relieve fuel pressure in line. (See page 5-2.)
  • Disconnect high pressure fuel pump wire connector located on fuel vapor separator.

• Always turn ignition switch “OFF” and disconnect battery cables when wires are being disconnected or connected.
• Hold and pull connector pieces when disconnecting. Do not pull wires.

• The self-diagnostic code memory in ECM will remain even if battery is disconnected.
• As each terminal voltage is affected by battery voltage, use a full-charged battery.
• Make sure all ground points have good electrical contact.
• Make sure all wires/cables are securely connected.

INSPECTION FOR ECM CIRCUIT VOLTAGE

ECM cannot be bench checked. It is strictly prohibited to connect any tester (voltmeter or ohmmeter) to an ECM separated from the engine wiring harness.

09930-89910 : 4-pin test cord – (1)
09930-89920 : 6-pin test cord – (2)
09930-89930 : 8-pin test cord – (3)
09930-89940 : 12-pin test cord – (4)
09930-99320 : Digital tester

Tester range : V (DC voltage)

(1) Connect the test cord (1), (2), (3) or (4) between ECM and wire harness as shown.
(2) Turn ignition switch ON.
(3) Connect the tester probe (-) (Black) to body ground, and measure voltage according to the “CIRCUIT VOLTAGE TABLE”.

CIRCUIT VOLTAGE TABLE

Share on social:

Produits associés