PRÉPAREZ-VOUS POUR L'HIVER : de 10 % à 50 % de réduction sur toutes les pièces d'origine !

Sauf interdiction par le fabricant. N'inclut pas les produits de rechange ou de marque Crowley Marine. Prix indiqué.

Nos entrepôts sont fermés le jeudi 26 et le vendredi 27 novembre. Joyeuse fête de Thanksgiving des États-Unis!

Recherche Plus d'un 1 million de pièces d'équipementier
Facile à utiliser  schémas des pièces Meilleur prix  garanti Assistance en directexperte   Plus de 50 ans  au service des plaisanciers Grand choix de pièces OEM  -  de 1950 à 2026 La plupart des pièces en stock  -  Exécution le jour même
Pièces en stock- Exécution le même jour

Service Manual DF40, DF50 Fuel Injection Control System [54][Df40, Df50]

Produits associés:
Service Manual DF40, DF50 Fuel Injection Control System [54][Df40, Df50]
99500-87J08-01E
Suzuki Marine

ELECTRONIC FUEL INJECTION SYSTEM

The fuel injection system used by the DF40/50 is a speed-density, multi-point, sequential, electronic fuel injection type. The fuel injection system is composed of the fuel line components, air intake components , and components for system control (ECM,sensors, switches, etc.).

FUEL INJECTION CONTROL SYSTEM

FUEL INJECTION CONTROL SYSTEM

OUTLINE

The sensors monitor current engine condition and send signals to the ECM. Based on these signals, the ECM determines the optimum fuel injection time duration (fuel amount) and fuel injection timing (multi point sequential timing) and controls the injector operating signals accordingly.
Fuel injection start timing is set at BTDC 545° on exhaust stroke constant.

FUEL INJECTION TIMING CHART

CONTROL MODE

BEFORE START :

When the ignition switch is turned “ON”, the ECM receives a MAP sensor signal, indicating the static barometric pressure of the intake manifold, which is used to compensate the fuel injection map for altitude.

WHEN CRANKING :
Fuel is simultaneously injected to all cylinders every time any piston is positioned at compression stroke.

AFTER START (FAST-IDLE FUNCTION):
The fuel injection amount is controlled to increase until the timer, set according to cylinder temperature at the time of engine start, expires.

WHEN IDLING / TROLLING :
The fuel injection amount is controlled to maintain a stable engine speed at the specified idle / trolling rpm.

WHEN ACCELERATING :
The fuel injection amount is controlled to increase.

WHEN DECELERATING :
The fuel injection amount is controlled to decrease.
The fuel injection is also cut off on very rapid engine deceleration.

Share on social:

Produits associés