Service Manual DF200AP Power Head[Engine Control[Diagnostic Information And Procedures][Self-Diagnostic Code “8 – 3” Esa (Electronic Shift Actuator)]]

Wiring Diagram

Troubleshooting

Step 1

1. Check the shift position sensor output voltage.
   Refer to “Shift Position Sensor Power Source and Output Voltage Inspection" in Section 1C (Page 1C—24).

Is the result OK?

Yes Go to Step 2.

No Faulty shift position sensor.

Step 2

1. Remove the main relay from fuse box.
   Remove the clutch link rod from clutch lever.

2. To check smooth gear engagement, shift the clutch control lever to Forward and Reverse position from Neutral position.

Is the result OK?

Yes

• Faulty ESA
• Faulty shift position sensor wire connection and/or continuity.
• If the wiring and connection is OK, intermittent trouble or a faulty ECM may be the cause.

No Shift link mechanism failure.