PRÉPAREZ-VOUS POUR L'HIVER : de 10 % à 50 % de réduction sur toutes les pièces d'origine !

Sauf interdiction par le fabricant. N'inclut pas les produits de rechange ou de marque Crowley Marine. Prix indiqué.

Nos entrepôts sont fermés le jeudi 26 et le vendredi 27 novembre. Joyeuse fête de Thanksgiving des États-Unis!

Recherche Plus d'un 1 million de pièces d'équipementier
Facile à utiliser  schémas des pièces Meilleur prix  garanti Assistance en directexperte   Plus de 50 ans  au service des plaisanciers Grand choix de pièces OEM  -  de 1950 à 2026 La plupart des pièces en stock  -  Exécution le jour même
Pièces en stock- Exécution le même jour

Service Manual 5008738_115-200 HP 60° V Routine Service [Spark Plugs]

Produits associés:
Service Manual 5008738_115-200 HP 60° V Routine Service [Spark Plugs]
5008738
BRP Marine

ROUTINE SERVICE

  • Single Ram System–Add Evinrude/Johnson Biodegradable TNT Fluid, as needed, to bring level to the bottom of the fill plug threads.

Install the filler cap and tighten to a torque of 45 to 55 in. lbs. (5 to 6 N·m).

  • Disengage tilt support.

  • Cycle the unit at least five complete cycles to purge all air from the system. When cycling the unit, hold the trim switch ON an additional 5 to
    10 seconds after the unit reaches the end of its travel before activating the switch in the opposite direction.

SPARK PLUGS

Spark plugs should be removed and examined periodically. Replace worn, fouled or damaged spark plugs.

Use only recommended spark plugs with the correct gap setting.

Spark Plug, Champion
QC10WEP @ 0.028 ± 0.003 in. (0.71 mm)

  • Remove spark plugs and inspect condition.

  • Set spark plug gap on new, replacement spark plugs.

  • Mark spark plugs for ground electrode orientation.

  • Apply Electrical Grease to the ribbed portion of the spark plug ceramic and to the opening of the spark plug cover to prevent corrosion.

  • Install spark plugs using “indexing” procedure.

Indexing
Spark plug indexing positions the ground electrode of the spark plug opposite the fuel injector nozzle.

Put an ink mark on the ceramic of the spark plug in line with the OPEN side of the ground electrode. This mark will be used to orient the spark plug with the OPEN side of the ground electrode facing the fuel injector.

Apply Triple-Guard grease to the gasket surface of the spark plug. Install spark plug and tighten to a torque of 15 ft. lbs. (20 N·m).

If the mark is in unshaded area do not tighten anymore.

If the mark is in the shaded area, reset torque wrench to 30 ft. lbs. (41 N·m) and continue to turn until the mark is in the unshaded area.

If the mark does not reach the unshaded area before the torque of 30 ft. lbs. (41 N·m) is reached, the spark plug cannot be indexed for that cylinder.
Try another spark plug and repeat the steps above.

FUEL AND OIL SYSTEMS

Routine replacement of filters reduces the possibility of foreign material restricting the incoming fuel or oil supplies.

Replacement filter elements are available through Evinrude/Johnson Genuine Parts.

Fuel Filter

Evinrude E-TEC V-model outboards are equipped with a water-sensing, water-separating fuel filter. Refer to FUEL COMPONENT SERVICING on p. 146.

Share on social:

Produits associés