PRÉPAREZ-VOUS POUR L'HIVER : de 10 % à 50 % de réduction sur toutes les pièces d'origine !

Sauf interdiction par le fabricant. N'inclut pas les produits de rechange ou de marque Crowley Marine. Prix indiqué.

Nos entrepôts sont fermés le jeudi 26 et le vendredi 27 novembre. Joyeuse fête de Thanksgiving des États-Unis!

Recherche Plus d'un 1 million de pièces d'équipementier
Facile à utiliser  schémas des pièces Meilleur prix  garanti Assistance en directexperte   Plus de 50 ans  au service des plaisanciers Grand choix de pièces OEM  -  de 1950 à 2026 La plupart des pièces en stock  -  Exécution le jour même
Pièces en stock- Exécution le même jour

Service Manual 5008732_15-30 HP Manual Starter [Recoil Starter Installation]

Produits associés:
Service Manual 5008732_15-30 HP Manual Starter [Recoil Starter Installation]
5008732
BRP Marine

RECOIL STARTER INSTALLATION

Position the wiring in the retaining bracket of recoil starter housing.

  1. Wiring
  2. Retaining bracket

Install recoil starter assembly . Tighten mounting screws to a torque of 31 to 48 in. lbs. (3.5 to 5.5 N•m).

  1. Screws

Install stator connector in retainer groove of starter housing.

  1. Stator connector

To prevent damage to wiring from rotating flywheel, make sure stator connector is securely fastened to the starter housing.

Position the vapor separator vent hose and wiring in the retainers on the recoil starter housing as shown.

  1. Retainers

Position the charge module harness, connectors and wiring as shown.

Assemble and tighten tie straps through the tie strap slots of the recoil housing.

Attach fuse holder to retainer.

Attach remaining connectors to retainers on recoil housing as shown.

  1. Battery charge module harness
  2. Tie straps
  3. Fuse holder

Position the EMM on the starter housing. Inst all and tighten self-taping screws carefully.

IMPORTANT: Turn self-tapping screws counter clock-wise to start the threads and clockwise to tighten. Failure to follow this procedure can damage the threads of the housing.

  1. EMM
  2. Self-tapping screws

Connect the cooling hose to the EMM. Secure Connect the cooling hose to with tie strap.

RECOIL STARTER DISASSEMBLY

Wear safety glasses while disassembling and assembling manual starters because of rewind spring tension.

Use Starter Spring Winder and Installer, P/N 342682, to service the recoil starter assembly.

  1. Base
  2. Retainer
  3. Left-hand threaded nut
  4. Stop tool
  5. Handle

Pull the starter rope out completely. Retain pulley in position by placing the stop tool from Starter Spring Winder and Installer, P/N 342682 through the hole in the pulley.

  1. Stop tool
Share on social:

Produits associés