PRÉPAREZ-VOUS POUR L'HIVER : de 10 % à 50 % de réduction sur toutes les pièces d'origine !

Sauf interdiction par le fabricant. N'inclut pas les produits de rechange ou de marque Crowley Marine. Prix indiqué.

Nos entrepôts sont fermés le jeudi 26 et le vendredi 27 novembre. Joyeuse fête de Thanksgiving des États-Unis!

Recherche Plus d'un 1 million de pièces d'équipementier
Facile à utiliser  schémas des pièces Meilleur prix  garanti Assistance en directexperte   Plus de 50 ans  au service des plaisanciers Grand choix de pièces OEM  -  de 1950 à 2026 La plupart des pièces en stock  -  Exécution le jour même
Pièces en stock- Exécution le même jour

Service Manual 5008330_55 HP MFE Gearcase [Impeller Service Mjrl Models]

Produits associés:
Service Manual 5008330_55 HP MFE Gearcase [Impeller Service Mjrl Models]
5008330
BRP Marine

PROPELLER SERVICE, MRL MODELS

Inspection

Carefully examine propeller and outboard for the following:

  • Damaged blades and signs of propeller cavita tion (burned paint, etc.)
  • Spun or overheated inner hub
  • Worn or twisted splines and inadequate lubri cant
  • Damaged or missing converging ring (if applica ble)
  • Damage to outer hub area
  • Worn, missing, or incorrect thrust washer and spacer
  • Correct size and style
  • Check for bent or damaged propeller shaft and twisted splines.

Refer to Propeller Hardware Installation on p. 42.

When servicing the propeller, always shift the outboard to NEUTRAL, turn the key switch OFF, and disconnect the battery positive (+) cable so the outboard cannot be started accidentally.

IMPELLER SERVICE, MJRL MODELS

Inspection

To prevent accidental starting while servicing, twist and remove all spark plug leads.

Use a 3/16 Ballhex driver to remove the six impeller housing screws. Remove the impeller housing.

Insert a 1/8 in. shim between the impeller and the impeller housing. If the shim moves freely for the entire length of the impeller blade tip on any of the blades, the impeller is worn and must be replaced.

Rotate the impeller 30° and repeat the inspection.

Removal

Wedge a block of wood between impeller blade and starboard side of the gearcase. Remove the cotter pin and loosen the impeller nut.

Remove the nut, spacer, impeller, and thrust bushing.

  1. Cotter pin
  2. Impeller nut
  3. Spacer
  4. Impeller
  5. Thrust bushing

Installation

Apply a small amount of Triple-Guard grease to the impeller shaft splines. Place the thrust bushing in the impeller and then slide the assembly onto the impeller shaft.

Install the spacer on splines of the impeller shaft.

Wedge a block of wood between impeller blade and port side of the gearcase. Install and tighten the impeller nut to a torque of 120 to 140 in. lbs. (14 to 16 N·m).

If cotter pin holes in the impeller nut and impeller shaft are not aligned, continue to tighten the nut until they are in line. Do not loosen.

Insert a new cotter pin through the impeller nut and shaft. Bend its ends over the nut to secure the assembly.

Install the impeller housing, and following
sequence shown, tighten screws in stages to a
torque of 70 to 100 in. lbs. (8 to 12 N·m).

Share on social:

Produits associés