PRÉPAREZ-VOUS POUR L'HIVER : de 10 % à 50 % de réduction sur toutes les pièces d'origine !

Sauf interdiction par le fabricant. N'inclut pas les produits de rechange ou de marque Crowley Marine. Prix indiqué.

Recherche Plus d'un 1 million de pièces d'équipementier
Facile à utiliser  schémas des pièces Meilleur prix  garanti Assistance en directexperte   Plus de 50 ans  au service des plaisanciers Grand choix de pièces OEM  -  de 1950 à 2026 La plupart des pièces en stock  -  Exécution le jour même
Pièces en stock- Exécution le même jour

Service Manual 5007215_Evinrude E-TEC 200-250 HP Installation And Predelivery [Before Start Up]

Produits associés:
Service Manual 5007215_Evinrude E-TEC 200-250 HP Installation And Predelivery [Before Start Up]
5007215
BRP Marine

BEFORE START-UP

Gearcase Lubricant

With outboard in vertical position, check the gear case lubricant level:

  • Remove the lubricant level plug. Lubricant must be even with the bottom of the threaded hole.
  • A clean tie strap can be used as a “dip stick” if the lubricant level is not obvious.
  • Add HPF XR gearcase lubricant as needed.

  1. Gearcase lubricant level

Oil Level

Make sure oil tank contains an adequate supply of the correct lubricant for the outboard and that the SystemCheck Low Oil Warning test has been performed.

When starting the outboard for the first time, refer to Oil Supply Priming on p. 67.

Trim and Tilt Fluid

Make sure trim and tilt reservoir is full before running outboard:

  • Tilt the motor up and engage the tilt support.
  • Remove filler cap and check fluid level.
  • If necessary, add enough Evinrude/Johnson Power Trim/Tilt and Power Steering Fluid to bring fluid level even with bottom of fill cap hole when unit is at full tilt.

  1. Filler cap
Share on social:

Produits associés