PRÉPAREZ-VOUS POUR L'HIVER : de 10 % à 50 % de réduction sur toutes les pièces d'origine !

Sauf interdiction par le fabricant. N'inclut pas les produits de rechange ou de marque Crowley Marine. Prix indiqué.

Nos entrepôts sont fermés le jeudi 26 et le vendredi 27 novembre. Joyeuse fête de Thanksgiving des États-Unis!

Recherche Plus d'un 1 million de pièces d'équipementier
Facile à utiliser  schémas des pièces Meilleur prix  garanti Assistance en directexperte   Plus de 50 ans  au service des plaisanciers Grand choix de pièces OEM  -  de 1950 à 2026 La plupart des pièces en stock  -  Exécution le jour même
Pièces en stock- Exécution le même jour

Service Manual 15-30 HP Routine Service [Anti-Corrosion Protection]

Produits associés:
Service Manual 15-30 HP Routine Service [Anti-Corrosion Protection]
5008326
BRP Marine

ANTI-CORROSION PROTECTION

Sacrificial Anodes

Galvanic corrosion occurs in fresh or salt water. Salt, brackish, and polluted water can accelerate corrosion. “Sacrificial” anodes are intended to protect the underwater metal components of the outboard from galvanic corrosion.

Manual tilt outboards are equipped with one sacrificial anode. Power tilt outboards are equipped with two sacrificial anodes.

  1. Stern bracket anode (Power tilt models only)
  2. Gearcase housing anode

Visually inspect anodes and metal components below water level. Erosion of anodes is normal and indicates the anodes are functioning properly.

Anodes that are not eroding may not be properly grounded. Anodes and the mounting screws must be clean and tight for effective corrosion protection.

For best anode performance:

  • Replace all anodes that have eroded or disintegrated to two-thirds of their original size
  • Do not paint or apply protective coatings to anodes or anode fasteners
  • Avoid using metal-based antifouling paint on the boat or outboard.

Testing Procedure – Continuity

Connect ohmmeter leads between engine ground and anode surface.

  1. Meter lead to anode

The meter should show little or no resistance. If resistance is high, check the following:

  • Remove the anode and clean the area where the anode is installed
  • Clean the mounting screws
  • Install the anode and test again.

Metallic Component Protection

Protect metal components on outboards from corrosion. Use the following products to minimize corrosion:

  • Anti-Corrosion Spray provides a heavy, waxy coating to protect components
  • “6 in 1” Multi-Purpose Lubricant provides a thin film of anti-corrosion protection.

Exterior Finishes

Maintain the outboard’s exterior finish to prevent corrosion and reduce oxidation:

  • Use automotive wax to protect the outboard’s exterior finish from oxidation.
  • Clean regularly using clean water and mild detergent soap.
  • Touch-up damage to painted surfaces promptly.
Share on social:

Produits associés