PRÉPAREZ-VOUS POUR L'HIVER : de 10 % à 50 % de réduction sur toutes les pièces d'origine !

Sauf interdiction par le fabricant. N'inclut pas les produits de rechange ou de marque Crowley Marine. Prix indiqué.

Nos entrepôts sont fermés le jeudi 26 et le vendredi 27 novembre. Joyeuse fête de Thanksgiving des États-Unis!

Recherche Plus d'un 1 million de pièces d'équipementier
Facile à utiliser  schémas des pièces Meilleur prix  garanti Assistance en directexperte   Plus de 50 ans  au service des plaisanciers Grand choix de pièces OEM  -  de 1950 à 2026 La plupart des pièces en stock  -  Exécution le jour même
Pièces en stock- Exécution le même jour

Owner's Manual DF60A, DF40A, DF50A Break-In

Produits associés:
Owner's Manual DF60A, DF40A, DF50A Break-In
99011-88L70-03B
Suzuki Marine

BREAK-IN

Proper operation during this break-in period wil welp ensure maximum life and performance from your engine. The following guidelines will explain proper break-in procedures.

Failure to follow the break-in procedures described below can result in severe engine damage.
Be sure to follow the engine break-in procedures described below.

Break-in period: 10 hours

Break-in procedure

  1. For the initial 2 hours:
    Allow sufficient idling time (about 5 minutes) for the engine to warm up after cold engine starting.

Running at high speed without sufficient warm-up may cause severe engine damage such as piston seizure.
Always allow sufficient idling time (5 minutes) for the engine to warm-up before running at high speed.

After warming up, run the engine at idling speed or the lowest in-gear speed for about 15 minutes.
During the remaining 1 hour and 45 minutes, if safe boating conditions permit, operate the engine in gear at less than 1/2 (half) throttle (3000 r/min.).

You may throttle up beyond the recommended operating range to plane your boat, then immediately reduce the throttle to the recommended operating range.

  1. For the next 1 hour:
    Safe boating conditions permitting, operate the engine in gear at 4000 r/min. or at threequarter throttle. Avoid running the engine at full throttle.
  2. Remaining 7 hours:
    Safe boating conditions permitting, operate the engine in gear at desired engine speed.
    You may occasionally use full throttle; however do not operate the engine continuously
    at full throttle for more than 5 minutes at any time.

Running continuously at full throttle for more than 5 minutes at a time during the
last 7 hours of break-in operation may cause severe engine damage such as seizure.
During the last 7 hours of break-in operation, do not operate at wide open throttle
for more than 5 minutes at a time.

Share on social:

Produits associés