PRÉPAREZ-VOUS POUR L'HIVER : de 10 % à 50 % de réduction sur toutes les pièces d'origine !

Sauf interdiction par le fabricant. N'inclut pas les produits de rechange ou de marque Crowley Marine. Prix indiqué.

Nos entrepôts sont fermés le jeudi 26 et le vendredi 27 novembre. Joyeuse fête de Thanksgiving des États-Unis!

Recherche Plus d'un 1 million de pièces d'équipementier
Facile à utiliser  schémas des pièces Meilleur prix  garanti Assistance en directexperte   Plus de 50 ans  au service des plaisanciers Grand choix de pièces OEM  -  de 1950 à 2026 La plupart des pièces en stock  -  Exécution le jour même
Pièces en stock- Exécution le même jour

Lower Unit [Lower Unit] [2008]

Produits associés:

Applicable Models

Model group Year Model Serial
Yamaha International 2001 - 2005 4hp All
Yamaha Outboard 1999 - 2005 4hp All

Lower Unit [Lower Unit] [2008]
LIT-18616-01-79
Yamaha Marine

EXPLODED DIAGRAM

REMOVAL AND INSTALLATION CHART

Step Procedure/Part name Q'ty Service points
LOWER UNIT REMOVAL Follow the left "Step" for removal.
1 Cotter pin 1 Not reusable
2 Propeller nut 1
3 Washer 1
4 Propeller 1
5 Spacer 1
6 Bolt (anode) 1
7 Toothed washer (anode) 1
8 Anode 1
9 Grommet 1
10 Bolt (shift rod connector) 1 NOTE:
Set the shift lever to reverse position, and loosen the bolt (shift rod connector).

Step Procedure/Part name Q'ty Service points
11 Bolt with washer (lower unit) 2 For S-transom model
*For L-transom model
NOTE:
When removing, screw out the bolt (rear) from upper case and remove the lower unit with extension.
12 Lower unit ass'y 1
13 Lower unit with extension 1 For L-transom model
14 Dowel pins 2
15 Dowel pins 2 For L-transom mode
16 Circlip 1
17 Bushing 1
Reverse the removal steps for installation.

SERVICE POINTS

Lower unit removal

NOTE:

  • It is possible to remove the Lower unit from the upper case without removing the power unit.
  • Set the shift lever (1) to "REVERSE" position, then remove and install the lower unit.
  1. Remove:
  • Grommet (2)
  1. Loosen:
  • Bolt (3) (shift rod connector)

  1. Remove:
  • Bolt (1) (lower unit)

  • Lower unit (2)

NOTE:
For long transom model:

  • When removing, screw out the bolt (rear) from upper case and remove the lower unit with extension.
  • When installing, hold the bolt (rear) in hole of the extension and install the lower unit with extension to the upper case.

Lower unit installation

  1. Tighten:
  • Bolt (1) (shift rod connector)

NOTE:
Push down the tilt lock plate (2) until it contacts the stopper and locate the shift lever in "REVERSE" position. Then tighten the bolt (1).

Share on social:

Produits associés