PRÉPAREZ-VOUS POUR L'HIVER : de 10 % à 50 % de réduction sur toutes les pièces d'origine !

Sauf interdiction par le fabricant. N'inclut pas les produits de rechange ou de marque Crowley Marine. Prix indiqué.

Nos entrepôts sont fermés le jeudi 26 et le vendredi 27 novembre. Joyeuse fête de Thanksgiving des États-Unis!

Recherche Plus d'un 1 million de pièces d'équipementier
Facile à utiliser  schémas des pièces Meilleur prix  garanti Assistance en directexperte   Plus de 50 ans  au service des plaisanciers Grand choix de pièces OEM  -  de 1950 à 2026 La plupart des pièces en stock  -  Exécution le jour même
Pièces en stock- Exécution le même jour

Electrical System [Lower Unit And Related Parts] [1986]

Produits associés:
Electrical System [Lower Unit And Related Parts] [1986]
LIT-18616-00-06
Yamaha Marine

Choke solenoid

  1. Disconnect the choke solenoid leads from the choke solenoid and wire harness.
  2. Check the choke solenoid as specified using the pocket tester.

Continuity.................................Normal
Discontinuity.............................Defective

  1. If the element is broken, replace the entire unit.

Installation

Refer to page 4-41.

Power trim and tilt motor

Removal
Refer to page 5-18.

Disassembly

  1. Loosen the wire harness bolt, and remove the two bolts securing the frame end.
  2. Remove the commutator end by tapping on it with a plastic hammer.

1. Remove the lead wire while taking care not to break it.
2. Spray WD-40 on the lead, so the frame can easily be removed.

  1. Wire harness bolt
  2. Commutator end
  1. Remove the brushes from the brush holder, and by tapping the frame end with a plastic hammer, remove the frame end.
  2. Remove the armature from the frame end.

  1. Armature
  2. Frame end

INSPECTION AND REPAIR

Armature

  1. Check surfaces of the commutator. Using sandpaper (#500 or #600), smooth out any rough surface. If roughened excessively, turn the commutator in a lathe. If its run-out is 0.2 mm (0.008 in) or more, take the same step.
  2. Measure the commutator mica undercut. If the depth is 0.2 mm (0.008 in) or less, cut it to the specification.

Under cut: 0.4 ~ 0.8 mm (0.015 ~ 0.03 in)

  1. Check continuity between the armature coil and ground.
    If there is continuity, the armature coil is grounded and therefore, it should be replaced.
Share on social:

Produits associés