PRÉPAREZ-VOUS POUR L'HIVER : de 10 % à 50 % de réduction sur toutes les pièces d'origine !

Sauf interdiction par le fabricant. N'inclut pas les produits de rechange ou de marque Crowley Marine. Prix indiqué.

Nos entrepôts sont fermés le jeudi 26 et le vendredi 27 novembre. Joyeuse fête de Thanksgiving des États-Unis!

Recherche Plus d'un 1 million de pièces d'équipementier
Facile à utiliser  schémas des pièces Meilleur prix  garanti Assistance en directexperte   Plus de 50 ans  au service des plaisanciers Grand choix de pièces OEM  -  de 1950 à 2026 La plupart des pièces en stock  -  Exécution le jour même
Pièces en stock- Exécution le même jour

Electrical System [Ignition Control System] [1998]

Produits associés:

Applicable Models

Model group Year Model Serial
Yamaha International 1998 25hp All
Yamaha Outboard 1998 25hp All

Electrical System [Ignition Control System] [1998]
LIT-18616-01-77
Yamaha Marine

IGNITION CONTROL SYSTEM (E, ET)

(1) Pulser coil
(2) Oil pressure switch
(3) Engine temperature sensor
(4) Low-oil-pressure warning lamp
(5) CDI unit

B : Black
Br : Brown
P : Pink
R : Red
W : White
Br/B : Brown/Black
P/W : Pink/White
R/W : Red/White
Y/R : Yellow/Red

IGNITION CONTROL SYSTEM (EH, EHT)

(1) Pulser coil
(2) Oil pressure switch
(3) Engine temperature sensor
(4) Low-oil-pressure warning lamp
(5) CDI unit

B : Black
Br : Brown
P : Pink
R : Red
W : White
Br/B : Brown/Black
P/W : Pink/White
R/W : Red/White
Y/R : Yellow/Red

PULSER COIL

Refer to "IGNITION SYSTEM".

OIL PRESSURE SWITCH

  1. Measure:
    • Oil pressure switch continuity
    Out of specification -> Replace

Mity Vac: YB-35956/90890-06756

Oil pressure switch continuity pressure

15.5 kPa (1.55 kg/cm2,2.25 psi) and above No continuity
15.5 kPa (1.55 kg/cm2, 2.25 psi) and below Continuity

ENGINE TEMPERATURE SENSOR

  1. Measure:
    • Output voltage (at the specified temperature)
    Out of specification -> Replace.
    Refer to the following chart.

LOW-OIL-PRESSURE WARNING LAMP

  1. Check:
    • LED (Light emitting diode) lighting
    No lighting -> Replace.

Battery voltage: 1.5 V

Yellow/Red lead -> Positive terminal.
Pink/White lead -> Negative terminal.

Use a conventional AA penlight battery (1.5 V). An alkaline or higher voltage battery can burn out the diode.

LED has a direction for electrical current. Therefore try reverse connection if there is no lighting.

Share on social:

Produits associés